Waves System NanoPlayer Manual - page 8
® Waves System
V 1.0 - 2008
I.D. AL - NanoPlayer Lecteur MP3 et Wav autonome - Mode d'emploi
1 - Speaker Output: The NanoPlayer includes a built-in amplifier. The board can therefore be connected
directly onto speakers. Connect the speaker wires onto the output of each of the 2 channels.
Caution: Never connect outputs between themselves, do not create short-circuits and do not use
speakers with lower impedance than specified in the player specification.
2 - Audio Output: on the line level stereo output, connect an amplifier, sound system, mixer or any
device providing a line level input. The 4 pins connector offers an internal connection link.
3 - Luminous indicator: a red LED displays the status of the player
LED off: the player is not powered or in stand-by mode
LED flashing quickly (2 flashes per second): the player is reading
LED flashing slowly: Error signal - for example when memory card is empty
4 + 8 - Power supply: If the player is powered with a filtered and regulated power supply unit or a
battery, the recommanded tension is 12V DC, even if the player can be powered between 10V and 15V.
The current used will depend on the power of the amplifier.
5 - Infrared: The NanoPlayer can be controlled with a infrared remote handset (not supplied with the
- 6 -
Left speaker
Right speaker
Left output
Ground
Ground
Right output
Stereo audio output on mini-jack 3.5
Connect a PSU or a 12V battery - The 2 pins connector allows internal
supply when the board is integrated. Diode protection against polarity
reversal.
OEM board - available separately).