Wavetek AD105 Operator's manual - page 15
Courant Continu (Sélection Automatique)
Gamme
Résolution
Précision
0 à 100A
0.1A
±(2.9%lect + 8dgt)
100A à 400A
0.1A
±(1.9%lect + 5dgt)
400A à 1000A
1A
±(2.9%lect + 5dgt)
Courant Alternatif (40 - 400Hz; Sélection Automatique)
Gamme
Résolution
Précision
0 to 40A
0.1A
±(1.9%lect + 8dgt)
40A to 400A
0.1A
±(1.9%lect + 7dgt)
400A to 1000A
1A
±(2.9%lect + 5dgt)
Conversion CA: Couplage CA , mesure efficace vraie, calibrée pour sinuoïdale.
Précisions données pour sinuoïdales à pleine échelle. Pour ondes déformées,
ajoutez les corrections de facteur de crête suivantes:
Facteur de Crête 1.4 à 2.0, ajoutez 1.0% à la précision.
Facteur de Crête 2.0 à 2.5, ajoutez 2.5% à la précision.
Facteur de Crête 2.5 à 3.0, ajoutez 4.0% à la précision (0 - 400A).
Compteur de Fréquence
Gamme
Résolution
Précision
4KHz
1Hz
±(0.5%lect + 3dgt)
10KHz
10Hz
±(0.5%lect + 3dgt)
Fréquence d’entrée min: 20Hz;Sensibilité, 1kHz à 10kHz: 10A eff. (
Peak Hold (Maintien valeur max)
Gamme
Résolution
Précision
LOW
0.1A
±(3.0%lect + 10dgt)
HIGH
1.0A
±(3.0%lect + 10dgt)
TROUBLESHOOTING/REPAIR
If there appears to be a malfunction during the operation of the meter, the
following steps should be performed in order to isolate the cause of the
problem:
❶
Check the battery.
❷
Review the operating instructions for
possible mistakes in operating procedure.
❸
Check clamp against a
known current source.
Except for the replacement of the battery, repair of the clamp should be per-
formed only by a Factory Authorized Service Center or by other qualified
instrument service personnel.
Front panel and case can be cleaned with a mild solution of detergent and
water. Apply sparingly with a soft cloth and let dry completely before using.
Do not use aromatic hydrocarbons or chlorinated solvents for cleaning.
D • Fehlersuche/Reparatur
Bei Problemen bitte folgendes prüfen:
❶
Batterie Ladung,
❷
Meßprozedur
❸
Einen bekannten Stromwert mit der Zange prüfen.
Mit Ausnahme des Batteriewechsels sollte jede Reparatur der Stromzange nur
durch eine Wavetek-anerkannte Servicestelle vorgenommen werden.
Das Gehäuse kann mit einer milden Seifenlösung gereinigt werden. Vor
– 15 –
AD105.Man.07.00 11/30/00 6:18 PM Page 15