Wayne-Dalton 3018 Installation Instructions And Owner's Manual - Warning
please do not return this product to the store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at
1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
30
alternate programming for homelink
®
to the classicdrive
®
I
note: This Step can only be done on automobiles equipped with the
HomeLink
®
System.
note: Programming HomeLink
®
requires a Wayne-Dalton
Transmitter that is programmed to the opener (transmitter(s) sup-
plied with the opener, come pre-programmed from the factory). Any
additional transmitter(s) will need to be programmed to the opener, see
page 32.
IMportant: use the programming instructions provided with your
vehicle first. Follow these instructions if the HomeLink
®
unit does not
learn the transmitter, when using the vehicle’s instructions.
note: Vehicle may need to be in accessory position when
programming. Check car owner’s manual.
note: HomeLink
®
is a registered trademark of johnson Controls.
programming/training homelink
®
unit
GARAGE DOOR MAy OPERATE DuRING PROGRAMMING. TO AVOID
POSSIBLE SEVERE OR FATAL INjuRy, PLACE THE EMERGENCy
DISCONNECT HANDLE IN THE MANuAL OPERATED POSITION.
1. Pull the manual disconnect to put the opener in the disengaged
position.
2. Press and hold the two outside buttons on the HomeLink
®
unit until
the HomeLink
®
indicator light begins to flash rapidly (approx. 20
seconds), then release both buttons. (Do not perform this step to train
additional hand-held transmitters.)
note: This operation erases all
previously learned transmitters and that you need to re-teach any other
transmitters to your HomeLink
®
unit by repeating steps 3 - 6 below.
3. Hold the end of the Wayne-Dalton hand-held transmitter
approximately 1 to 3 inches away from the HomeLink
®
surface
keeping the HomeLink
®
indicator light in view.
4. Press and hold the Wayne-Dalton hand-held transmitter’s large
center button. The transmitter’s red indicator light will turn on. After 10
seconds the red indicator light will blink rapidly. Do not release the
button and proceed to the next step.
5. Press the desired HomeLink
®
button. Do not release either button
until step 6 has been completed.
note: It is important to immediately
press the HomeLink
®
button as soon as the transmitter’s red indicator
light blinks. If the red indicator light subsequently turns on or off ignore
it, this is normal.
6. The HomeLink
®
indicator light will be blinking during the training
operation. When the HomeLink
®
indicator light flashes rapidly or turns
off (approx. 5 to 60 seconds), both buttons may be released. The
HomeLink
®
indicator light flashing rapidly or turning off indicates
successful programming of the new frequency signal. Verify transmitter
has been learned by pressing the HomeLink
®
button used to learn the
transmitter; HomeLink
®
indicator light will come on without flashing or
flash rapidly indicating a successful learn.
teaching homelink
®
to the opener
7. Press the program switch on the opener. The red program status
light on the opener and light will turn on and remain lit for one minute,
indicating that it is ready to learn.
8. Press the HomeLink
®
button used in Step 5 above for 1 to 3
seconds. The program status light on the opener will turn on and off
three times indicating a successful learn.
9. Press the HomeLink
®
the opener will activate and the trolley will
travel towards open, the next activation will cause the trolley to travel to
the closed position and reengage, subsequent operations will move the
door.