Webasto Diesel Cooker x100 Service Manual - page 24
Webasto Diesel Cooker X 100
5 Updating and repair
502
1.
Copy all files from the CD on to your computer’s hard
disk to the location of your choice.
2.
Install the PC cable into an available COM port. You
may need a USB-COM adapter to install the cable if
your laptop does not have a COM port.
(Note! Make sure you choose the right USB adapter)
3.
Connect the PC cable to the XPS card as illustrated in
Figure 2.
Note! The coupler has 5 studs in use; one stud has
been soldered shut: There is only one way you can
connect the PC cable to the control unit.
4.
Connect the electrical and control panel wires to the
control unit and turn the stove on.
5.
Start the programme by double-clicking on the
xplink.exe file, located on your computer’s hard disk.
XPlink will open up as illustrated in Figure 1(see
previous page).
6.
Choose the correct COM port (COM1 ...COM4,
depending on your computer’s settings).
When you have succeeded in getting the correct COM
port to work, the control unit’s amount of operating
hours and programme version will be displayed on the
Xplink operating system (Figure 1).
7.
Click “File” > Open > AI.xpd (always use the last file
that was used)
8.
There are two ways to update a single device:
8.1
You can update all parameters by clicking on “Choose
all”.
Click on “Export”
The parameters of all devices are updated at the
same time; this takes just a few moments. When the
parameter update has succeeded, the text “...file
transfer ok...” will appear on the screen after a few
seconds. If the data transfer has been unsuccessful,
the operating sustem will display an error message on
the screen.
8.2
You can also update the parameters of just one
device. In this case, DO NOT click on “Choose all”.
Next, choose the appropriate device from the pop-
down menu.
“Device 17”.
Click on “Export”.
Loading may take 1 to 2 seconds.
When the parameter update has succeeded, the text
“...file transfer ok...” will appear on the screen after a
few seconds. If the data transfer has been
unsuccessful, the operating system will display an
error message on the screen.
9.
When the parameter update has been successful,
detach the PC cable from the control unit.
10.
You can use the new parameters immediately.
Figure 2
PC cord connector
PC connection on XPS card