Webasto Dual Top Evo 6 Operating Instructions Manual - page 7
Dual Top Evo 6
Operating Instructions
7
During normal operation you will see the status display. See Fig. 2.
7 = Indicator Heater ON/Heater OFF
8 = Remote indicator
9 = Drainage indicator
10 = Interior heating/temperature indicator
11 = Water heating/temperature indicator
ad 1 and 2:
Press up button (1)
to increase and down button (2)
to
decrease desired temperature, set correct time and date, etc., move
blinking cursor and to scroll through menu.
ad 6:
The power indicator lights up
GREEN
when the Dual Top Evo is
switched on and START (3) is pressed. Also Heater ON on display (7).
The heater is operating or in the standby mode.
Power indicator is off when STOP (3) is pressed or when Dual Top Evo
is switched off. Also Heater OFF on display (7). The heater is not
operating or is not in the standby mode.
The indicator flashing pulses
RED
if a fault has occurred.
ad 7:
The heater is ON when the Dual Top Evo is switched on and START (3)
is pressed. The heater is operating or in the standby mode.
The heater is OFF when STOP (3) is pressed or Dual Top Evo is switched
off. The heater is not operating or is not in the standby mode.
ad 8:
Symbol “ “ appears when device is ready to accept signals of remote
control.
ad 9:
The “ ” symbol is shown when the electrical safety/drainage valve is
opened.
ad 10:
Desired interior temperature is displayed, not actual temperature.
ad 11:
Desired water temperature is displayed, not actual temperature.
Background lighting
The background lighting of the display lights up when the Dual Top Evo equipment is
switched on, no matter if there is heater operation or not.
It will fade out after some minutes if no button is pressed.
Backlight will light up again after pressing
or
.
NOTE
The display may become darker when the temperature of the control panel becomes
very high or when it is placed in direct sunlight.
Avoid that the control panel is exposed to high temperatures or direct sunlight.
In case aforementioned conditions could not be avoided, adjust display contrast in
“ Setup” (see paragraph 3.4.2: "Language, temperature unit, hour format, display
contrast").
Fig. 2
Status display
7
8
9
11
10