Webasto Dual Top Evo 6 Operating Instructions Manual - page 9
Dual Top Evo 6
Operating Instructions
9
3.3.3
Switching off the heater
Proceed as follows to completely switch off the Dual Top Evo:
1
Press the On/Off button
to switch off the device.
Now the heater will stop heating.
2
The fan can continue to run after switching off in order to cool down the
heater.
“Shutting down...” on display.
3
After the cooling phase the fan switches off.
For 1 hour the display shows text ”Webasto Dual Top” as well as actual
time, day and date.
Always drain the boiler if there is a risk of frost!
See paragraph 3.7: "Frost".
Stopping heating operation to select another mode:
1
Press STOP.
Now the heater will stop heating.
2
The fan can continue to run after switching off in order to cool down the
heater.
Display shows stopped heating mode.
*
Power indicator (6) goes off and “Heater OFF” (7) on display.
3
Use menu to select another mode.
After the cooling phase the fan switches off.
When after some minutes no button is touched, the display shows text
”Webasto Dual Top” as well as actual time, day and date.
3.3.4
Setting desired interior temperature
When the appliance is switched on (see paragraph 3.3.2) and the status display is
visible, you can set the desired interior temperature.
**
The status display shows the motor home and the current heating program. See Fig. 2.
Press
to increase or
to decrease the temperature.
NOTE
Desired temperature is displayed, not actual interior temperature.
Selected interior temperature can be changed, no matter if heater is ON or OFF. As soon
as heater is switched on (manually, by remote control or timer) in a cabin heating mode,
appliance will heat interior and keep it at this temperature.
* Exception: in case the last used heating mode was initiated by remote control
(Telestart or Thermo Call), the last non-remote control heating mode is shown.
** If actual heating mode is initiated by remote control, desired interior
temperature cannot be adjusted. Dual Top will heat up interior and keep the
temperature at preset value, selected when setting Thermo Call or Telestart.