1. DL manuals
  2. Webasto
  3. Transmitter
  4. Telestart T91
  5. Operating And Servicing Manual

Webasto Telestart T91 Operating And Servicing Manual

Summary of Telestart T91

  • Page 1

    Telestart t91.

  • Page 2: Deutsch

    Deutsch 1 svenska 99 english 15 norsk 113 français 29 suomi 127 italiano 43 polski 141 español 57 Č esky 155 nederlands 71 német 169 dansk 85 Русский 183 d gb f i e nl dk s n fin pl cz h rus.

  • Page 3: T91

    15 d gb operating and servicing manual t91 general information dear webasto customer! We are delighted that you have selected this webasto product. We assume that the workshop / service partner that carried out the installation explained to you the operation and principle of functioning of your tele...

  • Page 4: Must Not

    16 dd gb the heater must not be operated : in filling stations, fuel depots and refineries. In places where explosive vapours or dust may build up (e.G. Near fuel, coal, wood dust or cereal stores). Close to inflammable materials such as: dry grass and leaves, cardboard packaging, paper, etc. In enc...

  • Page 5: Use

    17 d gb use using the webasto telestart t91, you can switch webasto heaters (thermo top e, thermo top c, thermo top p, thermo top v) or the vehicle fan on and off at a long distance via a wireless link. To switch on the parking ventilation*(ventilation of the interior of the vehicle), the mode has t...

  • Page 6

    18 dd gb optimum signal transmission is achieved out in the open or from a position higher than the vehicle.In this case, the auxiliary heating system can be operated at a distance of approx. 1000 m from the vehicle. When operating the transmitter, please hold it vertically pointing upward and do no...

  • Page 7: Off

    19 d gb programming telestart transmitter 1. Place batteries into the battery compartment of the transmitter. 2. Remove fuse 1a (black) from the heater's fuse holder (voltage interruption). 3. Wait at least 5 seconds. 4. Replace fuse in heater's fuse holder and within 5 seconds press the off -button...

  • Page 8: Checking Mode

    20 dd gb checking mode simultaneously depress and hold down the on - and off -buttons. Led illuminates: red = heating mode green = ventilating mode* led extinguishes: – when the buttons are released, or – after 10 seconds *the “parking ventilation“ function is not available with upgrade of auxiliary...

  • Page 9: Red

    21 d gb feedback from transmitter upon turning on/off switch on heater or ventilation* hold the transmitter with the aerial upright and press the on button until the led lights up (approx. 1 second). The transmitter will send a feedback signal. The led on the hand-held transmitter indicates whether ...

  • Page 10: Note:

    22 dd gb note: in the 'heating' mode, the vehicle's heating system is to be set to "warm" prior to leaving the vehicle. In the 'heating' and 'ventilation' modes*, the vehicle's fan switch is to be turned to position 1 in the case of 3-speed blower fans, and to position 2 in the case of 4-speed blowe...

  • Page 11: Note:

    23 d gb switching on/off using pushbutton switch the parking heater or parking ventilation mode is indicated by a light in the pushbutton. Note: when the pushbutton switch is used for activating the heater, the operating mode (parking heating or parking ventilation) and operating duration most recen...

  • Page 12: Note:

    24 dd gb checking and setting operating time the operating time of the heater or the vehicle's fan can be preset on the transmitter in increments of 10 minutes.The operating time is factory-set at 30 minutes. Note: we recommend setting the heating time according to the drive time. Example: the vehic...

  • Page 13: Checking Operating Time

    25 d gb checking operating time simultaneously actuate the on - and off buttons within one second three times in succession. Note: the first coded flashing signal that is emitted immediately upon the third actuation of both buttons has to be included into the count. The led flashes in accordance wit...

  • Page 14: Setting The Operating Time

    26 dd gb setting the operating time press the off button to call up the next operating time. To store the setting: – do not actuate any button for 10 seconds, or – actuate the on button. Returning to default setting press the on - and off buttons simultaneously for approx. 10 seconds until the led e...

  • Page 15: Checking Battery

    27 d gb checking battery press the on - or off button. Battery led action almost spent flashes orange for 5 seconds replace battery as soon as possible or warm up transmitter discharged lights up for 5 seconds in orange replace battery or.

  • Page 16: Battery Change

    28 dd gb battery change see also page 19, "programming telestart transmitter" . Note return batteries of our products after use at the point of purchase or in its immediate vicinity. Returning them is free. As end user you are legally obliged to return used batteries. Caution! Risk of explosion if b...

  • Page 17: Webasto Ag

    Bei mehrsprachiger ausführung ist deutsch verbindlich. In multilingual versions the german language is binding. Dans le cas d'une version rédigée en plusieurs langues, l'allemand est alors la langue qui fait foi. Nel caso di una versione plurilingue il tedesco è vincolante. Si existen versiones en v...