- DL manuals
- Webasto
- Transmitter
- Telestart T91
- Operating Instructions Manual
Webasto Telestart T91 Operating Instructions Manual
Summary of Telestart T91
Page 1
Telestart t91 1314649b_ba_t91.Book page 1 tuesday, january 31, 2012 9:42 am.
Page 3: General Information
18 gb operating instructions for telestart t91 general information dear webasto customer! We are delighted that you have selected this webasto product. We presume that the principle and mode of operation of this product has been explained to your complete satisfaction by the workshop/service centre ...
Page 4: Care And Handling
19 gb care and handling note the following points to avoid damage to the telestart t91: • do not expose to heat above 70 °c (e.G. Direct sunlight). • operating temperature between 0 °c and +50 °c. • only store in a dry place where there is little dust. • do not immerse in water. The heater must not ...
Page 5: Use
20 gb use with the webasto telestart t91, the webasto heaters of the thermo top series or the vehicle fan can be switched on and off wirelessly from a great distance. With the thermo top evo heater which is connected to the telestart t91 via w bus communication, a change in the mode must be carried ...
Page 6
21 gb optimum signal transmission is achieved out in the open or from a position higher than the vehicle. In this case, the parking heater can be operated at a distance of approx. 1000 m from the vehicle. When operating the transmitter, please hold it vertically pointing upward and do not cover the ...
Page 7
22 gb teaching in telestart transmitter for thermo top e and c 1. Insert the battery in the battery compartment of the transmitter. 2. Remove the 1 a fuse (black) from the heater's fuse holder (voltage interruption of receiver). 3. Wait at least 5 seconds and refit the fuse. 4. After approximately 2...
Page 8
23 gb teaching in telestart transmitter for thermo top evo as described above for the thermo top e and c, however remove either 1 a fuse (black, vehicle interior) or 30 a fuse (green, engine compartment) (voltage inter- ruption for receiver). Or min. 5 s. Min. 5 s. Min. 2 s. Max. 6 s. Min. 1 s. 1314...
Page 9: Checking Mode
24 gb checking mode simultaneously press and hold down the on- and off-but- tons. Led lights up: red = heating mode green = ventilation mode* led extinguishes: – when the buttons are released, or – after 3 seconds * please observe the information under "use". Setting mode depress the on- and off but...
Page 10: Red
25 gb feedback from transmitter upon turning on/off switching on heater or ventilation* hold the transmitter with the aerial upright and press the on button until the led lights up (approx. 1 second). The telestart receiver in the vehicle transmits a confirmation of the reception (see overview above...
Page 11: Note:
26 gb note: if no special instructions on adjusting the vehicle heater during parking heating operation are available, then the vehicle heater must be set to "warm" before switching on the heater. In the heating and ventilation modes, the vehicle fan switch is to be turned to po- sition 1 in the cas...
Page 12: Note:
27 gb switching on/off using pushbutton switch the parking heating or parking ventilation mode is indicated by a light in the push- button. Note: when the pushbutton switch is used for activating the heater, the operating mode (parking heating or parking ventilation) and the operating duration most ...
Page 13: Note:
28 gb switching on with telestart t91 with digital timer installed operation is indicated on the digital timer. The display lighting lights up. Note: this display is only possible with the thermo top evo heater, as it is connected to the telestart t91 via w bus communication. Switching off using a d...
Page 14: Note:
29 gb checking and setting operating time the operating time of the heater or the vehicle's fan can be preset on the trans- mitter in increments of 10 minutes. The operating time is factory-set at 30 min- utes. Note: make sure that the car battery is recharged sufficiently if you use the system fre-...
Page 15: Checking Operating Time
30 gb checking operating time simultaneously briefly press the on and off button three times consecutively. The led flashes in accordance with the preset operat- ing time. Note: the first coded flashing signal that is emitted immediately upon the third actuation of both buttons has to be included in...
Page 16: Setting Operating Time
31 gb setting operating time press the off button to call up the next operating time. To store the setting: – do not actuate any button for 10 seconds, or – actuate the on button. Returning to factory setting simultaneously press the on and off button for at least 15 seconds. Note: colour changes on...
Page 17: Caution:
32 gb procedure after not using for longer time when the hand-held transmitter is not used for longer periods, we recommend removing the battery from the hand-held transmitter to increase battery life. Caution: do not store in the vehicle, but instead in a dry place at room temperature. Returning to...
Page 18: Checking Battery
33 gb checking battery press the on or off button. Led battery action lights up for 2 sec- onds in green or red full battery ok attention: heater could be activated or deactivated in the process. Flashes for 2 sec- onds in green or red full battery ok attention: receiver too far away or trans- mitte...
Page 19: Note:
34 gb battery change/disposal information note: batteries and electronic devices are the object of the european directive 2006/66/ec or 2002/96/ec in the current versions and must not be disposed of as household waste. Every consumer is therefore legally obligated to dispose of batteries and used/sc...
Page 20
D bei mehrsprachiger ausführung ist deutsch verbindlich. Die telefonnummer des jeweiligen landes entnehmen sie bitte dem webasto servicestellenfaltblatt oder der webseite ihrer jeweiligen webasto-landesvertretung. In multilingual versions the german language is binding. The telephone number of each ...