Summit tm 450 & 650 lp gas barbecues step-by-step guide 72627 10/25/00 w e b e r w e b e r w e b e r w e b e r danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid 4. If odor continues, keep away from the appliance and immediately call your gas suppli...
“u” rails (2) continue to remove packaged contents 2 tools needed supplies needed 7/16 inch open end or an adjustable wrench you will need a soap and water solution to check for gas leaks. (see step "check for gas leaks.") note - the hardware size of nuts, bolts and screws is given. For example "1/4...
3 remove packaged contents (continued) cylinder hanger stainless steel work surface (2) condiment holder (2) tool holder (4) bottom shelf warm-up basket 1/4-20 wing nuts (4) thermometer.
4 a) b) install “u” rails figure 1 “u” rail support mounts tabs frame rails “u” rail supports note: lock the casters before starting assembly. You will need: two “u” rails, eight 1/4-20 x 1/2 inch bolts, eight nylon washers, and a 7/16 inch or adjustable wrench. Insert the tabs of the “u” rail into ...
5 install steam-n-chips smoker you will need: smoker box. Remove the center flavorizer bar (the one that is not over a burner). Set the handles of the steam-n-chips smoker on the flavorizer bar holder. Note: for directions on how to use the steam-n-chips smoker, see the operating guide. Install flav...
6 add cooking grates you will need: (1) cooking grate and (1) hinged cooking grate . The cross-rail of the cooking grate goes down. Set the cooking grates in place next to each other. Warning: use heat-resistant barbecue mitts or gloves when adding wood to the steam-n-chips smoker. Use a barbecue to...
7 install warm-up basket you will need: warm-up basket. Install one end of the warm-up basket into the hole on the right end of the lid and the other end into the slot in the left end of the lid. Summit 450 summit 650 install bottom tray you will need: bottom tray, catch pan holder, catch pan, and o...
8 install bottom shelf place the bottomshelf under the cart between the frame supports. Lift up one end of the shelf so it clears the crosspiece. Continue to lift until the opposite end clears the opposite crosspiece. Set the shelf in place on both crosspieces. 8 slide the bottom tray into the mount...
9 install condiment holders and work surfaces figure 11 you will need: two condiment holders, two stainless steel work surfaces, and four wing nuts. Place the condiment holders on the left and right side of the frame. Figure 11(a). Set the work surfaces over the condiment holders on both sides of th...
10 important lp cylinder information failure to follow these danger statements exactly may result in a fire causing death or serious injury. Danger never store a spare lp cylinder under or near this barbecue. Never fill the tank beyond 80% full. Your weber gas grill is equipped with a cylinder suppl...
11 safe handling tips for liquid propane gas cylinders • liquid propane (lp) gas is a petroleum product as are gasoline and natural gas. Lp gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder, lp gas is a liquid. As the pressure is released, the liquid read...
12 check for gas leaks remove burner control knobs, control panel(1) and front panel(2) remove the burner control knobs. The control panel(1) is separate from the front panel(2). The control panel needs to be removed before the front panel can be removed. Front edge of the control panel put your fin...
13 pull the front panel(1) up and out of the cooking box assembly. Summit 450 summit 650 danger do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily in...
14 14 manifold a) b) c) manifold figure 19 check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak. Warning: do not ignite burners while checking for leaks. Check: a) left valves to manifold connection...
15 figure 20 (b) (a) a) hose to regulator connection. Figure 20 (a). B) regulator to tank connection. Figure 20 (b). Warning: if there is a leak at connections 19 (a), 19 (b), 20 (a), or 20 (b) turn off the gas. Do not operate the barbecue. Contact your dealer. When leak checks are complete, turn ga...
16 reinstall control panel front panel control panel you will need: control panel. Pull igniter buttons up until they stay in the up position. Place the control panel into the grooves on either side of the front of the cooking box. Push the control panel into place, using even pressure while pushing...
17 reinstall burner control knobs you will need: four burner control knobs. Push on the burner control knobs. Summit 450 summit 650 install tool holders you will need: four tool holders. Place the tool holder under the control panel(1) and over the front panel(2). Set the tool holder on top of the f...
18 18 summit 450 lp 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 36 35 72 66 67-71 65 64 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 39 40 38 37.
19 19 19 1 left pivoting endcap 2 shroud assembly 3 stainless steel handle 4 thermometer 5 hinged cooking grate 6 stainless steel work surface (2) 7 condiment holder (2) 8 steam-n-chips smoker 9 flavorizer bar / cooking grate holder (2) 10 igniter (2) 11 manifold mounting clips (2) 12 manifold assem...
20 20 20 w eb er w e b e r 1 2 3 4 5 6 7 8 9 10 11 12 13 14-17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 40 38 39 37 41 42 43 44 45 47 46 48 49 50 51 55 56 57 62 60 64-67 58 69 70 71 72 75 76 61 68 63 74 73 52 54 53 59 35 36 33 34 summit 650 lp.
21 summit 650 lp w e b e r w e b e r warning: use only weber factory authorized parts. The use of any part that is not factory authorized can be dangerous. This will also void your warranty. 1 left pivoting endcap 2 shroud assembly 3 stainless steel handle 4 cooking grates (2) 5 flavorizer bars(11) ...