WebGate WebEye A10 User Manual

Other manuals for WebEye A10: User Manual

Summary of WebEye A10

  • Page 1

    Webeye a10 user’s guide v 1.5 1 - webgate inc. Webeye a10 user’s guide.

  • Page 2

    Webeye a10 user’s guide v 1.5 2 - i. Introduction webeye a10 is an audio transmission kit that can use with connect ing to webeye e10/e104. Users may hear real-time sound with image from remote place through webeye’s homepage co nnected to webeye a10, and use for remote -monitoring, audiovisual conf...

  • Page 3

    Webeye a10 user’s guide v 1.5 3 - iii. Webeye a10 connection 1. Connecting with webeye e104 1) connect dedicated cable between webeye e104 and webeye a10 2) check led on webeye a10. Led goes on when it is powered and blinks when transmit ting data. * there is no need to connect external power supply...

  • Page 4

    Webeye a10 user’s guide v 1.5 4 - * connecting external camera and webeye a10 to webeye e10 through db-15 port.

  • Page 5

    Webeye a10 user’s guide v 1.5 5 - 3. Connecting webeye a10 to webeye b101 1) connect power supply to webeye a10 2) cut provided dedicated cable (refer to figure 1) 3) prepare 3 wires (rx, tx, and gnd) to connect to b101. (power wire is not used with b101) 4) connect the 3 wires to webeye b101 and rj...

  • Page 6

    Webeye a10 user’s guide v 1.5 6 - 4. Connecting webeye a10 to webeye b106 1) connect power supply to webeye a10 2) cut provided dedicated cable (refer to figure 1) 3) prepare 3 wires (rx, tx, and gnd) to connect to b106. (power wire is not used with b106) 4) connect the 3 wires to webeye b106 and rj...

  • Page 7

    Webeye a10 user’s guide v 1.5 7 - 5. Connecting webeye a10 to webeye spd 1) connect power supply to webeye spd 2) cut provided dedicated cable (refer to figure 1) 3) prepare 3 wires (rx, tx, and gnd) to connect to spd. (power wire is not used with spd) 4) connect the 3 wires to webeye spd and rj-45 ...

  • Page 8

    Webeye a10 user’s guide v 1.5 8 - 6. Configuring webeye 1) start web browser and access webeye. 2) enter administration page of webeye. 3) select ‘serial configuration ’ in administration menu. 4) select ‘serial #1’ in serial configuration for port #1 5) select ‘audio device’ in ‘select attached dev...

  • Page 9

    Webeye a10 user’s guide v 1.5 9 - v. Reference facts 1. Access condition • audio quality depends on upload rate of internet, round trip time betwee n user and webeye, and packet loss degree. • when webeye is connected to adsl/isdn/ppp or connection state is bad, audio may be cut off or may not be op...