WebGate WebEye A10 User Manual - page 3
WebEye A10 User’s Guide V 1.5
3 -
III. WebEye A10 connection
1. Connecting with WebEye E104
1) Connect dedicated cable between WebEye E104 and WebEye A10
2) Check LED on WebEye A10. LED goes on when it is powered and blinks when transmit ting
data.
* There is no need to connect external power supply to the A10 since WebEye E104
supplies power to WebEye A10 through dedicated cable.
2. Connecting with WebEye E10
1) Connect power supply to WebEye A10
2) Connect dedicated cable between WebEye E10 and WebEye A10
3) Check LED on WebEye A10. LED goes on when it is powered and blinks when transmitting
data.
* Make sure not to initially connect dedicated cable before supply ing power to
WebEye A10
Note in connecting cable to terminal block
When you connect cable to terminal block, you should peel off the cover of cable by 1.5Cm and
insert the cable by 2Cm into the terminal block.
1.5cm
Peeled
0.5cm
Covered
Total length to insert in Terminal Block = 2cm