WeBoost Drive 4G-X Installation Instructions Manual - page 6
6
ENGLISH
Need help?
www.weboost.com
Customer Support 866-294-1660
Roof mount only: For mounting the
antenna to the roof of your vehicle, use
weBoost #905814 (3/8 in . w/RG58 cable)
or #907414 (3/8 in . w/RG174 cable), which
must be purchased separately
(A)
. Drill a
hole in the desired location for mounting .
The size of the hole should be 3/8 in .
The plastic washer
(B)
should be placed
over the threads of the NMO mount
(A)
.
From the inside of the vehicle, insert the
threaded portion of the mount up through
the hole in the vehicle .
From the top of the vehicle, screw the
threaded nut
(D)
onto the mount threads
coming up through the roof and tighten until
secure .
The black rubber washer
(C)
should now
be positioned around the threaded nut .
Working from the inside of the vehicle,
securely route and position the cable
provided .
Screw the NMO antenna assembly
(E)
into
place on top of the vehicle .
Vehicle Surface
(B) Plastic Washer
(A) NMO Connector
Cable
(C) Rubber Washer
(D) Threaded Nut
(E) NMO Antenna
Assembly
Rubber Seal
Drilled Hole
To Booster
Alternate Outside Antenna
Installation: RV/Trucker
Antenna
Select a suitable location to install the
antenna on your RV, as high on the vehicle
as possible and at least 12 inches away
from any other antenna .
If you are installing on a mirror, clamp the
mount to the mirror support and tighten the
four nuts and bolts . If you are mounting
directly to the side of your RV, remove
the nuts, bolts and the smaller half of the
mount and use the four holes in the larger
half to attach it flush to the side of the RV,
using screws or bolts, nuts and washers
appropriate for your particular installation .
RV / Trucker Antenna
Mount & Hardware
To Booster