WeBoost EQO Installation Manual - Troubleshooting

Troubleshooting

Fixing Blinking or Solid 

Orange Lights

Fixing Blinking or Solid 

Red Issues

1. Unplug the power cable from the booster. 

2. Redirect the booster antenna to point in another direction. 

Typically, we recommend turning the booster 5-10 degrees at a 

time.

3. Plug power cable back in to booster.

4. Monitor the indicator lights on your booster. If, after 5 seconds of 

‘power on’, a solid or blinking orange light appears, repeat steps 1 

through 4.

5. If the solid or blinking orange light persists, and you are not 

experiencing the desired signal boost, more advanced trouble-

shooting may be necessary through weBoost Customer Support 

(866.294.1660).

1. Unplug the power cable from the booster. 

2. Relocate the booster and antenna further from each other. The 

objective is to increase the separation distance between them, so that 

they will not create this feedback condition discussed before. 

This section is only applicable if the booster is orange or blinking 

orange and you are not experiencing the desired signal boost.

This section is only applicable if the booster is orange or blinking 

orange and you are not experiencing the desired signal boost.

CELL PHONE SIGNAL BOOSTER

16