WeBoost EQO User Manual - Antenna Expansion Kit
Antenna Expansion Kit
Outside Fixed
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster
cannot be adjusted without factory reprogramming or disabling the hardware. The Signal Booster will
amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized
frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal
is detected.
If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the
Signal Booser will automatically reduce the gain on that specific band.
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of
the device.
Frequently Asked Questions
What hours can I contact customer support?
Why do I need to create distance between the booster and the antenna?
Customer Support can be reached from Monday through Sunday by calling
866.294.1660
,
or through our support site at support.
weboost
.com
Antennas connected to a booster create spheres of signal. When these spheres
overlap, a condition called oscillation occurs. Oscillation can be thought of as noise,
which causes the booster to shut down to prevent damage. The best way to keep
these spheres of signal from overlapping is to maximize separation between the
Booster and Antenna. ALWAYS orient the Booster and Antenna as shown on page 5.
(SPECIFICATIONS cont.)
CELL PHONE SIGNAL BOOSTER
6
50 Ohm Outside Antenna Kit — Mini Mag
301126 w/ 12.5 RG174 cable - SMA