Wecan E-STUDIO205L Troubleshooting Manual - Www.Wecan-Eg.Com
32 Abo Haya El Tawhedy,
Aria 7, Nasr City,
CAIRO.
WWW.WECAN-EG.COM
T:+2(02)26711737
T:+2(02)22758997
M:+2(02)01111134509
The print or fax job may be
incomplete. Press [JOB
STATUS] to check whether any jobs
are unfinished.
To clear the messages, press the
[FUNCTION
CLEAR] button twice.
A job was interrupted by a power
failure or some other reason.
POWER FAILURE
Corrective Action
Problem Description
Message
This message is displayed if the Data
Overwrite
Enabler (optional) is installed. You can
operate the
equipment while the message is
displayed
The Data Overwrite Enabler is
clearing the data
ERASING DATA
Register the paper size correctly. Just
releasing the
paper jam does not prevent another
paper jam.
P.38 “Clearing paper jams caused
by a wrong
paper size setting”
Paper jam has occurred because of a
mismatch between the paper size
placed in the bypass tray and the size
registered for the bypass tray in the
equipment.
Check paper size setting on control
panel for Bypass
Remove the jammed paper and set the
paper again.
The paper placed on the bypass tray
jammed.
Set the paper on the bypass tray
again.
Check the direction and the size of the
paper and then
replace it on the bypass tray.
The direction or the size of the paper
placed on the bypass tray is incorrect.
Check the direction or size of the
paper on the bypass tray and press
START
Rebooting the equipment may correct
the error. To
reboot the equipment, turn the main
power switch off
and then on
An error has occurred in the
equipment and it stopped normal
operation.
Reboot the machine
Install the toner cartridge correctly.
P.53 “Replacing a Toner Cartridge”
The toner cartridge is not installed. Or
it is not installed correctly
TONER NOT RECOGNIZED
Use a TOSHIBA-recommended toner
cartridge.
P.53 “Replacing a Toner Cartridge”
A toner cartridge not recommended
by TOSHIBA is being used.
Prepare a new toner cartridge.
(About another 1000 copies, set at the
time of
Toner is running out.
Toner near Empty
Replace the toner cartridge.
P.53 “Replacing a Toner Cartridge
No toner is left.
Install new toner cartridge
Remove the paper punchings.
P.70 “Cleaning the Hole Punch
Dust Bin”
The Hole Punch Unit dust bin is full.
Please Empty Hole Punch Waste
To print out the data for the originals
stored (scanned)
until the message appeared, press
[YES] on the touch
panel. To delete the stored data, press
[NO].
Internal memory available ran out
while scanning
Not enough Work Space to store
Originals Will you print out stored
originals?
Reduce the number of originals to be
scanned, and
try again.
The number of originals to be
scanned has exceeded the limit of
1000 sheets during scanning. (The
magazine sort or page number
function is used.)
The number of originals exceeds the
limits.
The scanned data are deleted
To print out the data for the originals
stored (scanned)
until the message appeared, press
[YES] on the touch
panel. To delete the stored data, press
[NO].
The number of originals to be
scanned has exceeded the limit of
1000 sheets during scanning.
The number of originals exceeds the
limits.
Will you copy stored originals?