Weewell WHC 714 User Manual - page 5
I
WHC714 User Manual
5
4.Unplug appliance during filling, cleaning and maintenance.
5.If there is any abnormal smell during normal operation, please switch off and
disconnect power supply and contact with service agent.
6.Never touch water in the Water Basin & components in the water when the unit is in
working.
7.Never switch on when there is no water in the water basin.
8.Never scrape Transducer.
9.Never clean Transducer with hazardous detergents, chemical solutions.
10.Never let water splash into inner Base Unit for avoiding components damage.
11.Be careful when using the appliance for emission of hot water vapor.
12.Before cleaning and maintenance, the appliance must be disconnected from the
supply main.
13.This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
14.Children should be supervised to ensure that they do not play with the appliance.
15.Indoor use only.
16.Prior to cleaning or other maintenance, the appliance must be disconnected from the
supply mains.
OPERATION INSTRUCTIONS:
Before the first operation, put unit under the room temperature for half of an hour
before operate.
It is recommended to use the unit under temperature of 20°C, in relative humidity less
than 80%RH.
Use only clear water not over 40°C.
Check the water basin, make sure it is clear.
Operation Instructions:
• Remove the mist unit from the water tank (Figure1). Take the water tank out of the
unit (Figure2), remove the water tank cover (Figure3), and fill the tank with clear water
(Figure4) not over 40
o
C then put back the cover (Figure5).
• Put the tank onto the base unit carefully (Figure6). Put the mist unit on the water tank
(Figure7).
• Put the machine on a flat surface. Connect the power plug and switch on the unit (NEVER
RUN THE UNIT WHEN THERE IS NO WATER IN WATER BASIN), the main connection lamp
will be on. The unit starts working.