Wegener iPump 562 Quick Start Manual - page 7
Main Menu
The main menu displays the unit serial number and currently tuned RF carrier settings at the top.
Current Program
Displays the current program number or descriptor. It may be changed by scrolling through the list of available programs,
using the up/down keys. If the unit is currently decoding a LAN/Ethernet stream, the IP and port of the stream is displayed
here.
Audio 1 Language
Displays the current audio program descriptor or “***”, which means the first available audio, for the Audio 1 output. It may be
changed by scrolling through the list of available audio’s, using the up/down keys. If the unit is currently decoding a
LAN/Ethernet stream, this will not be in the menu and the unit will decode the first audio in the stream.
Audio 2 Language
Displays the current audio program descriptor or “***”, which means the first available audio, for the Audio 2 output. It may be
changed by scrolling through the list of available audio’s, using the up/down keys. If the unit is currently decoding a
LAN/Ethernet stream, this will not be in the menu and the unit will decode the first audio in the stream.
Subtitling Setup
Navigates to the subtitling setup menu which allows enabling/disabling of subtitling and selection of the subtitling language.
Subtitling may be enabled only if closed captioning is in the Passthru mode.
Carrier Settings
Navigates to the carrier settings menu, which allows viewing/changing the tuned RF carrier settings, LNB parameters, signal
quality alarm settings and a signal strength meter.
Advanced
Navigates to the advanced menu, which allows more detailed monitor and control functions, such as viewing software
versions, decoder setup, and audio setup.
www.wegener.com
800092-02 Rev. C
7