Weider powerguide x2 User Manual - page 8
13
29. Before using the home gym system, tighten the
cables (see HOW TO TIGHTEN THE CABLES on
page 16 of this user’s manual). In addition, pull
each cable a few times to make sure that the
cables move smoothly over the pulleys. If the
cables do not move smoothly, locate and correct
the problem before using the home gym system
(see CABLE DIAGRAMS on page 17 of this
user’s manual). IMPORTANT: If the cables are
not properly routed, they may be damaged
when heavy weight is used.
Next, press down firmly on the Weight Bracket
(62) and securely tighten the indicated 5/16” Nylon
Locknut (1).
30. Remove the decals from the decal sheet (not shown), and apply them to the home gym system in the loca-
tions shown in the drawing below.
31. Make sure that all parts are properly tightened. The use of all remaining parts will be explained in ADJUST-
MENT, beginning on page 14 of this user’s manual.
30
MULTI-GYM
BENCH PRESS/
200 LBS
POWERGUIDE X2
8
12. Press two 1 3/4” Inner Caps (24) into each of the
Press Arms (29).
Lubricate one of the axles on the Press Frame
(33). Slide a Plastic Bushing (79) and a Press Arm
(29) onto the axle. Make sure that the upper end
of the Press Arm is between the Main Upright
(41) and the bracket on the Press Frame. Tap
two 1” Retainers (8) and a 1” Round Cover Cap
(30) onto the axle. Make sure that the teeth on
the Retainers are pointed toward the Plastic
Cover Cap. (See the inset drawing.)
Attach the other Press Arm (29) in the same
manner.
13. Wet the lower ends of the Press Arms (29) with
soapy water. Slide a 7” Foam Pad (25) onto each
Press Arm.
Attach a Handle (26) to one of the Press Arms (29)
with a 5/16” x 2 1/4” Bolt (80), two 5/16” Flat
Washers (5), a 1/2” x 13/32” Spacer (55), and a
5/16” Jam Nut (81) as shown.
Wet the Handle (26) with soapy water. Slide a 5”
Grip (27) onto the Handle. Press a 1” Round Cap
(9) into the other end of the Handle.
Attach the other Handle (26) to the other Press Arm
(29) in the same manner.
14. Attach a Cable Trap (69) and two 3 1/2” Thin
Pulleys (4) to the Main Upright (41) with the 3/8” x
5” Bolt (67) and a 3/8” Jam Nut (82). Do not tight-
en the Jam Nut yet.
12
13
14
29
79
33
8
30
24
24
24
24
29
Bracket
41
Lubricate
25
26
80
26
27
29
29
5
81
55
82
4
41
4
69
67
9
5
29
1
62
8
30
WEIGHT DECALS
12.5 LBS
125 LBS