Weider PRO 9645 User Manual - page 12
12
17. Attach the Left Pull-up Arm (75) and the Right
Pull-up Arm (77) to the Assist Upright (74)
with two 5/16” x 2 3/4” Bolts (11) and two
5/16” Nylon Locknuts (3).
Attach the Left Dip Arm (78) and the Right Dip
Arm (79) to the Assist Upright (74) with two
5/16” x 2 3/4” Bolts (11) and two 5/16” Nylon
Locknuts (3).
Wet the end of the Left Pull-up Arm (75) with
soapy water. Slide a Short Handgrip (113)
onto the Left Pull-up Arm. Repeat with the
Right Pull-up Arm (77).
Wet the end of the Left Dip Arm (78) with
soapy water. Slide a Long Handgrip (80) onto
the Left Dip Arm. Repeat with the Right Dip
Arm (79).
Press two 1 1/4” Round Inner Caps (109) into
the Left Pull-up Arm (75) and into the Right
Pull-up Arm (77).
Press a 1 1/4” Round Inner Cap (109) into the
Left Dip Arm (78) and the Right Dip Arm (79).
18. Locate and open the parts bags labelled
“CABLE ASSEMBLY” and “PULLEYS.”
During steps 19 through 39, refer to the
CABLE DIAGRAMS on page 27 of this manu-
al to verify proper cable routing. Before begin-
ning this section, fully unwind the four Cables.
Identify the four Cables by comparing the
lengths and ends of the Cables. The approxi-
mate length of each Cable is listed after the
key number in the drawing.
IMPORTANT: While assembling the cables,
do not overtighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
19. Locate the High Cable (58). Wrap the High
Cable around a 3 1/2” Pulley (15). Attach the
Pulley to the Top Frame (55) with a 3/8” x
3 3/4” Bolt (88) and a 3/8” Nylon Locknut (21).
Be sure that the end of the Cable with the
ball is on the indicated side of the Pulley
and that the Cable is between the Pulley
and the hook.
19
55
21
58
Ball
Hook
17
75
74
78
18
23 (200 cm)
58 (373 cm)
72 (483 cm)
99 (163 cm)
ARM ASSEMBL
Y
CABLE ASSEMBL
Y
11
109
109
109
109
11
77
113
113
80
80
3
3
3
15
88
109
79