Weider PRO 9645 User Manual - page 19
19
38. Locate the Leg Press Cable (99). Attach the
end of the Leg Press Cable to the Long “U”-
Bracket (57) with a 1/4” Nylon Locknut (2) and
a 1/4” Flat Washer (10). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
Wrap the Leg Press Cable (99) around a
3 1/2” Pulley (15). Attach the Pulley and a set
of Pulley Covers (114) to the Leg Press
Upright (56) with the 3/8” x 3 3/4” Bolt (88),
two 3/8” Flat Washer (9), and a 3/8” Nylon
Jam Nut (112). The ball on the Cable must
be on the indicated side of the Pulley. Be
sure that the Cable and Pulley move
smoothly and that the small tabs on the
Pulley Covers are in the indicated location.
39. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 3/8” x 3 1/4” Bolt (67)
and a 3/8” Nylon Locknut (21).
Wrap the Leg Press Cable (99) around a 3 1/2”
Pulley (15). Attach the Pulley and a set of
Pulley Covers (114) inside the Press Bracket
(94) with the 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21). Be sure the small tabs
on the Pulley Covers are in the position
shown.
Slide a 5/16” Flat Washer (8) onto a 5/16” x
2 3/4” Bolt (11). Insert the Bolt through the
lowest hole in the Rear Seat Frame (100)
from the indicated side and slide another
5/16” Flat Washer onto it. (Note: The three
holes are for cable adjustment.) Tighten a
5/16” Nylon Jam Nut (93) onto the Bolt. Slide
the end of the Leg Press Cable (99) onto the
end of the Bolt. Thread another 5/16” Nylon
Jam Nut onto the Bolt. Do not fully tighten
the second Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
39
CABLE ASSEMBL
Y
11
67
114
114
96
94
12
21
100
93
8
8
21
99
15
38
56
57
Ball
9
9
112
15
2
88
2
10
57
99
99
Welded
Rod
10
114
Small tabs
should be here.
Small tabs
should be
here.