1. DL manuals
  2. WoodPro
  3. Wood stove
  4. WS-TS-1500
  5. Owner's Manual

WoodPro WS-TS-1500 Owner's Manual

Other manuals for WS-TS-1500: Owner's Manual, Owner's Manual

Summary of WS-TS-1500

  • Page 1

    Www.Woodprostoves.Com 1-877-427-3316 ws-ts-1500 ws-ts-2000 ws-ts-2500 www.Woodprostoves.Com www.Woodprostoves.Com 4085-112 rev: c this manual describes the installation and operation of the brand “woodpro” wood heater. This heater meets the 2015 u.S. Environmental protection agency's crib wood emiss...

  • Page 2

    1. The installation of this stove must comply with your local building code rulings. Please observe the clear- ances to combustibles (see reference figures 4–8). Do not place fuel, furniture or any other objects within the clearance area. 2. Verify that the stove is properly assembled and installed b...

  • Page 3

    Safety instructions ...Continued woodpro™ / page 3 18. During the first 12 to 15 fires the special paints and pro- tective oils used in construction of your stove may give off some smoke and odor while they are curing. This should disappear after a short period of time and not occur again. Persons wit...

  • Page 4

    Table of contents page 4 woodpro™ table of contents ..................................................................................... 4 safety instructions ............................................................................. 1 – 3 assembly instructions .....................................

  • Page 5

    Locating the stove page 5 woodpro™ 1. The stove must be placed on solid concrete, solid masonry, or when installed on a combustible floor, on an underwriters laboratories listed type 2 floor protector listed to ul standard ul 1618, such as hy-c or imperial model ul4056bk. Floor protector must be 1/2˝/...

  • Page 6

    6 minimum clearances for installation according to ul 1482 (us) & ulc-s 627 (can) a.

  • Page 7

    7 top a a alcove a.

  • Page 8

    Philips blower attachment 8 (4 places) a gasket outside air kit (if required).

  • Page 9

    9 ws-ts-2500 23 8 6.

  • Page 10

    10 6.

  • Page 11

    Pipe sizing single wall pipe is used to make the connection from the final positioning of your stove to an approved chimney. Pipe is not included as part of the stove. Pipe must be 6”/152mm diameter minimum of 24 msg (minimum standard gauge) black or 26 msg blue steel stove pipe. Notice: for mobile h...

  • Page 13

    Masonry chimney the chimney must be a code-approved, masonry chimney with flue liner. Before using an existing ma- sonry chimney, clean the chimney, inspect the flue liner and make any repairs needed to be sure it is safe to use. Make repairs before attaching the stove. The connector stove pipe and fit...

  • Page 14

    Figure 12 - chimney construction through roof figure 13 - chimney connection to firebox through masonry wall manufactured chimney refer to chimney and chimney connec- tor maker’s instructions for installation and use. Use only 6˝/152mm diameter manufactured chim- ney system listed to ul 103 ht (us) ...

  • Page 15

    Tified chimney sweep, or a knowledgeable inspector. Consult your insurance company if you cannot find a qualified expert. Caution: not all fireplace chimneys are suitable for conversion to accom- modate connection to a wood stove. Check with a qualified expert. Many prefabricated fireplaces are of the “...

  • Page 16

    A. Brick masonry minimum 3.5˝/89mm thick brick masonry all framed into combustible wall with a minimum of 12˝/305mm brick separation from clay liner to combustibles. The fireclay liner shall run from outer surface of brick wall to, but not beyond, the inner surface of chimney flue liner and shall be fi...

  • Page 17

    Over firing may cause a house fire. You are over firing if a unit or chimney connector glowa red. Caution: house fire hazards continued on next page operating instructions 17 do not store wood on floor protector, underneath stovepipe, or anywhere within minimum clearances from combustible surfaces s...

  • Page 18

    Height, weather, log size, wood species and moisture content. Some experimentation will initially be required to find that “sweet spot” where your stove performs best. The following will give you a starting point to find your optimum settings. When first loading fuel set the primary air inlet con- trol...

  • Page 19

    7. Once fuel has been loaded, close the door and leave the air inlet control fully open until fire is well established (at least 15–20 minutes) being careful not to over fire (if any of the exterior parts of the stove or chimney connections begin to glow you are over firing the stove). 8. Re-adjust the...

  • Page 20

    20

  • Page 21

    21.

  • Page 22

    This wood heater needs periodic inspection and repair for proper operation. It is against federal regulations to operate this wood heater in a manner inconsistent with operating instructions in this manual. Whenever ashes get 3 to 4 inches deep in your firebox or ash pan, and when the fire has burne...

  • Page 23

    23 baffle removal.

  • Page 24

    24 baffle removal 1 for front baffle support and tube installation..

  • Page 25

    Service parts 25 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316..

  • Page 26

    Service parts 26 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316. Pkg of 6 pkg of 4 pkg of 4.

  • Page 27

    Service parts 27 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316..

  • Page 28

    Service parts 28 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316. Pkg of 6 pkg of 6 pkg of 4.

  • Page 29

    Service parts 29 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316..

  • Page 30

    Service parts ws-ts-2500 30 when requesting service or replacement parts for your appliance, please provide model number and serial number. All parts may be ordered by calling 1-877-427-3316..

  • Page 31

    Blower maintenance the optional blower is maintenance free other than cleaning. Lightly vacuum motor and air inlet to keep free of dust and dirt. Notice: any replace- ment wiring must have e q u i va l e n t i n s u l a - tion and temperature rating (105°c). Caution: moving parts can cause injury. D...

  • Page 32

    This stove has been tested for and must be installed on a floor protector with the proper thermal resistance or r-value as stated in step 1 of the installation instructions under “locating stove” section of this manual. If the floor protector ma- terials listed in the instructions are not available, m...

  • Page 33

    Date of service performed by description chimney & stove maintenance log 33.

  • Page 34

    Warranty 34 hearth & home technologies, inc. Woodpro limited warranty hearth & home technologies, inc. (hht), on behalf of its woodpro brand, extends the following warranty for woodpro appliances purchased from an authorized retailer. If you experience issues with your woodpro appliance, consumer ca...

  • Page 35

    Warranty 35.

  • Page 36

    36 www.Woodprostoves.Com 2.