X-Loupe A500 Assay series User Manual - page 6
- 8 -
- 9 -
Attention/Warning for the Battery Charging
Please use the included charger to charge the battery
and go by following steps to charge the battery
(1) Align the ▲ marks on the battery and charger, then insert the battery by sliding
it in 1 and down 2 .
(2) Plug the battery charger into the power outlet, or attach the power cord to the
battery charger and plug it into a power outlet then the Charging Signal will
light on.
- Steady Red: charging; Steady Green: charging completed.
Alternate Red and Green: battery malfunction
(3) If the Charging Signal does not light on after plug in the battery charger,
please check the following:
a Battery loose from the battery charger?
b Does the power outlet switch ON?
c Check other factors which might affect the power supply of the outlet.
d Ask the expert for help to check the power outlet, or change another one
and try again.
(4) After full charge, remove the battery from charger. Do not leave a fully charged
battery connected to a charger, since overcharging may shorten its lifetime.
Unplug the charger from the electrical plug when not in use.
(5) DO NOT use the battery charger in humid circumstances.
(6) DO NOT dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged. Dispose of batteries
according to local regulations.
Please recycle when possible.
DO NOT dispose as household waste.
Product Assembly
2 Mounting of Module and Camera :
Turn 30 degrees clockwise
(1) Align the mount positioning on the mount ring (at the rear of module) with the
red dot above the camera mount.(fig.
1
)
(2) Attach X-Loupe® module to camera and turn 30 degrees clockwise, until both
bodies are completely stable union.(fig.
2
)
(3) Turn on the camera and module power. The image will appear on LCD screen
the handling is correct. If the lens barrel can not extend properly, or error code
shows on camera monitor, please refer to the troubleshooting section of this
manual ; If unable to solve, please immediately contact your distributor for
assistance, do not try to modify X-Loupe® product by yourself in any way.
Red Dot
1
2
UN
LO
CK
LO
CK