X10 VT38A Owner's Manual - page 3
5
55
55
4
44
44
I
NSTALLING
THE
A
SSEMBLY
You can install the Motion Activated Camera in a wall box that is powered
at all times or in a wall box that is controlled by a wall switch, but if it is
controlled by a wall switch, make sure you leave the switch on at all times.
Turning the switch off will completely disable the motion activated camera.
CAUTION: To prevent severe damage to the unit, do not connect it to a
wall box that is controlled by any kind of dimmer or remote controlled
switch.
WARNING: Before making the following connections, be sure the
power to the junction box you are installing the motion activated
camera into is turned off. If not, a serious shock hazard will exist.
1. Install the gasket (supplied) onto the junction box, and route the house
wiring through the gasket.
2. Connect the GREEN wire from the mounting plate to the bare ground
wire in the junction box, or ground screw if there is one.
3. Connect the WHITE (Neutral) wire from the motion activated camera
assembly to the house wiring’s WHITE (Neutral) wire, using a wire nut.
4. Connect the BLACK (Live) wire from the motion activated camera
assembly to the house wiring’s BLACK (Live) wire, using a wire nut.
5. Make sure no bare whiskers of wire stick out from the wire nuts (cover
with electrical tape if necessary).
6. Secure the mounting plate to the junction box using the screws supplied.
7. Secure the insulating ring in each lamp holder and screw a bulb (max.
150W, not supplied) into each lamp holder.
Live
Neutral
Ground
A
SSEMBLING
THE
PARTS
Referring to the diagram below:
1. Screw the base of each lamp holder into the outer holes on the mounting
plate.
2. Rotate the locking ring on each lamp holder towards the plate until the
lamp holder is secure against the plate.
3. Screw the threaded end of the motion activated camera into the center
hole on the mounting plate.
4. Lock the motion activated camera into place using the locking ring.
5. Locate each lamp holder’s WHITE wire and one of the WHITE wires
from the motion activated camera and twist all three wires together
using a wire nut (supplied).
6. Locate each BLACK wire from the lamp holders and connect them
both to the BLUE wire from the motion activated camera, again using a
wire nut.
7. Make sure no bare whiskers of wire stick out from the wire nuts (cover
with electrical tape if necessary).
Bulbs not
included
Camera
Motion Sensor
White (Neutral)
Black (Live)
White
Black
White
Black
Bl
u
e
Wh
it
e
Wh
it
e
Bl
a
c
k
House Wiring
Wall Box Grounging Screw
Gr
e
e
n
Insulating ring