XCOM 760 Installation And User Manual - page 13
Release 1.2
© XCOM Avionics 2004
www.xcom760.com Page
13
Setup Options
Introduction
The setup screens are not programmable during normal use, as these options effect
how the transceiver will display screens, or operate in general. The following
procedure relates to programming these options and care should be taken. DO NOT
adjust the Microphone gain control unless you are confident to, read the
instructions and if in doubt have an avionics technician do the adjustment for you.
The setup parameters can also be changed via the RS-232 port using the windows
based SETUP utility, which can be downloaded at xcom760.com
Operation
The access the setup screen, press and hold at startup the following buttons:
DUAL - MODE - ON
The setup screen will appear; first it will display the current version number for 5
seconds, e.g.
1-01
The screen will then display the following setup options:
option
or
This selects the intercom to be on, or off (default is ON). In
the ON mode, the intercom is enabled in the transceiver
and the
and
appear in the MODE screen.
To set on or off simply rotate the F/CH control. Press the
F/CH to go on to the next option or Ú to return to the main
screen, the new values will be stored.
Note: Selecting the intercom to OFF aids in current
consumption savings, important for battery powered
applications like gliding.
option
or
This selects the Microphone sidetone ON or OFF
(Default is ON). Selecting ON enables the sidetone during
transmission, which can only be heard in the headsets.
Selecting OFF removes the sidetone. To set on or off simply
rotate the F/CH control. Press the F/CH to go on to the next
option or Ú to return to the main screen, the new values
will be stored.
Note: Selecting the SIDETONE to OFF aids in current
consumption savings, important for battery powered
applications like gliding.
-
This sets the HIGH point trip for the battery alert, Rotate
the F/CH control to set the upper limit. The default is 15