Xenarc 706TSA Installation Manual - page 9
9
|
Hardware Installation
In AV1/AV2 input Mode (There are two OSD in the AV1/AV2 mode):
On Screen Display functions "Picture" description:
In PC mode menu
On Screen Display functions "IMG.ADJ" description:
1.PICTURE: The picture of the picture is adjusted.
Phase: Image flicker can by halftone phase adjustment. That can regulate the
picture centre. (DVI does not have this one)
Frequencv: Frequency is adjusted. Adjust the Frequency mode by pressing the
image remove of left and right sides. (DVI does not have this one)
Sharpness: Sharpness definition is adjusted, the range is from 0 to 015 , the greater
number value is clearer.
Color temp: PC (R , G , B) are adjusted, three base color can do it from 0 to 256
color.
Auto sensor: Automatic to adjust screen sensor and environment light switch. The s
able be colse / the enable be open.
2. IMAGE: The picture of the img.adj is adjusted.
Image.SIZE: Set the display mode to Fall FULL/ Fall ASPECT(16:9/4:3)/1TO1(1:1).
Set it to 4:3 if your video signal is in 4:3 aspect ratio and you don't want the display
to be stretched out. Default is 16:9.
Freeze FRAME: Static picture switch.
Horizontal: Adjust Horizontal position by pressing the lncrease ( )/Decrease ( )
buttons.
Vertical: Adjust Vertical position by pressing the lncrease ( )/Decrease ( ) buttons.
Brightness: Adjust brightness by pressing the Increase ( )/Decrease ( ) buttons. Increase
the number for higher brightness. Decrease the number for lower brightness. The range is
from 0 to 100.
Contrast: Adjust contrast by pressing the Increase ( )/Decrease ( ) buttons.
Increase the number for higher contrast. Decrease the number for lower contrast.
The range is from 0 to 100.
Backlight: Adjust backlight by pressing the Increase ( )/Decrease ( ) buttons. Increase the
number for higher backlight. Decrease the number for lower backlight. The range is from 0 to
100.