XENO XDR4 range Installation And User Manual - 3.3 Ptz Operation
of
128
23 | Chapter 1 : DVR User Manual
3.3 PTZ Operation
User can go to PTZ mode by clicking right button of mouse and selecting
“PTZ” in the pop-up menu as shown below or by
selecting the joystick button
in the menu bar located on the bottom of the main screen.
In PTZ mode, user can control PTZ operation with USB mouse.
While pressing the left button of mouse, user can drag the mouse pointer to up/down or left/right to move pan/tilt position of
the camera. If user moves the mouse pointer far away from the center position of the main screen, the PTZ camera moves at
faster speed. The user can also zoom-in/out by rolling the wheel of mouse up or down.
N
OTE
Full PTZ functions are available by using USB mouse, IR remote control, or keyboard controller