B r a n d model sx150-1 automatic battery charger user’s manual rev. 1.0 october 17, 2006 the extreme battery charger ™ for sales, support and service phone: 407-331-4793 fax: 407-331-4708 website: www.Xenotronix.Com email: information@xenotronix.Com xenotronix/tli, inc. 2541 tracy road toledo, ohio...
Warranty seller warrants that its products ("product(s)") will meet the specifications set forth in its catalog from time to time, unless the buyer is notified otherwise prior to delivery. Seller will, without charge, repair or provide a replacement for any of the products which prove to be defectiv...
Table of contents model sx150-1 automatic battery charger – user’s manual important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 operati...
Optimizer tm sx150-1 user’s manual xenotronix/tli 1 important safety instructions save these instructions - this manual contains important safety and operating instructions for the model sx150-1 battery charger (optimizer). Before using the battery charger, please read all instructions and cautionar...
Optimizer tm sx150-1 user’s manual xenotronix/tli 2 introduction the optimizer has the best interests of your battery in mind. It is a high quality charger designed with efficient and reliable switching technology for recharging sealed lead-acid (sla) batteries. It is a current limited, constant pow...
Optimizer tm sx150-1 user’s manual xenotronix/tli 3 operating instructions before using this battery charger, make sure it is compatible with your battery. Refer to the ratings on the battery charger, the specifications in this manual, and your battery documentation. Charge only sealed or valve regu...
Optimizer tm sx150-1 user’s manual xenotronix/tli 4 attach the accessory harness to the battery noting the correct polarity. In some applications, this will be a short cable with ring terminals and an insulated polarized connector and may be permanently mounted to the battery. Connect the output cab...
Optimizer tm sx150-1 user’s manual xenotronix/tli 5 rest stage (heavy-cyclic mode only) after the equalize charge, the charger will enter a rest period for 1 hour before entering float charge stage. During the rest period, the charger will indicate that the battery is ready for use. Float charge sta...
Optimizer tm sx150-1 user’s manual xenotronix/tli 6 attached, unplug the charger, wait a few seconds until all lights are off, and plug the charger back into ac power. If the charger is damaged, it will indicate a fault after several seconds. Battery faults occur if the battery voltage is too high o...
Optimizer tm sx150-1 user’s manual xenotronix/tli 7 battery fault when 12v battery is attached – this occurs if the battery voltage is too low or too high. If you know you have a 12v battery, and not a 6v or 24v battery, check the battery voltage using a volt meter. If the battery has been so severe...
Optimizer tm sx150-1 user’s manual xenotronix/tli 8 battery charger specifications general conditions ambient temperature = 25ºc (77ºf) operating temperature 0 to 50ºc (32 to 122ºf) storage temperature -40 to 80ºc (-40 to 176ºf) input power requirements 110-127 vac, 50-60hz, 2a maximum charge curren...
