Xerox 4215 Installation Planning Manual - page 29
PREINSTALLATION
Printer language switch setting
The default language is set on the twinax interface board. The
twinax interface board can only be configured by your Xerox
service representative. The following twinax language options
are available for the twinax printer:
•
Belgium
•
Iceland
•
Brazil
•
International
•
Canada/France
•
Italy
•
Denmark/Norway
•
Japan (English)
•
Finland/Sweden
•
Portugal
•
France
•
Spain
•
Germany/Austria
•
Spanish speaking
•
Great Britain
•
United States/Canada.
DO NOT attempt to change the printer language switch after
installation.
Page size
The default page size is set by your Xerox service representative
when the printer language is set. Your choices are:
•
U. S. (8.5x11)
•
European A4 (8.27x11.69)
Printer device address
The device address switch sets the printer device address. Your
Xerox service representative needs to know what device address
has been assigned to the printer within your operating
environment. Available options are device addresses 0 through
6.
The printer device address can be changed at any time after
installation. Refer to the “Configuring the interface card” chapter
in the Xerox 4219/MRP 4215/MRP Mid Range Systems Printer
Operator Guide for further information.
Non-printable area
A border area on the outside edges of the paper is unavailable
for printing. This space is approximately .17 inch (4.2 mm) on
each side. Refer to the diagram below. The shaded area shows
the image area.
3-6
XEROX 4219/MRP AND 4215/MRP INSTALLATION PLANNING GUIDE