The document company xerox 8855 /721p stacker operator manual xerox wide format solutions 701p39432.
Prepared by: global knowledge and languages services 780 salt road webster, new york 14580 copyright© 2003 by xerox corporation. Allrights reserved. Xerox and all product names and number names are trademarks of xerox corporation. Other company trademarks are also acknowledged. Printed in u.S.A. 701...
1 table of contents it’s illegal ..................................................................... 2 fcc compliance ......................................................... 2 introduction to your stacker ...................................... 3 safety notes ........................................
2 it’s illegal in the usa it is against u.S. Law to copy copyrighted material without permission of the copyright owner unless the copying falls within the “fair use” library reproduction rights of the copyright law. Further information on these u.S. Provisions may be obtained from the copyright off...
3 introduction to your stacker congratulations on acquiring your new stacker. This user guide provides information that is needed to operate the stacker. The information below is needed when you call your xerox support experts. 1. Customer account number: __________________ 2. Stacker serial number:...
4 safety notes your stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, and compliance to established environmental standards. Please read the following instructions carefully before operating the stacker. Note: refer to inst...
5 safety notes (continued) unplug this stacker from the wall outlet and refer servicing to qualified service personnel under the following conditions: - when the power cord is damaged or frayed. - if liquid has been spilled into the product. - if the stacker has been exposed to rain or water. - if t...
6 identifying the parts on the stacker upper panel assembly stacker unit media supports frame assembly release handle thumb screws inlet power indicator light power switch printed wiring board (transmission) printed wiring board (reception) release handle.
7 location of the stacker serial number in order to locate the serial number of your stacker, you must first push down the release lever and slide the stacker away from the printer. The serial number plate is located on the left of the front cover facing the printer. Stacker operation if you are run...
8 stacker relocation the stacker cannot be moved except by a drc rigger. To ensure that the stacker operates reliably after moving it to a new location, consider the following guidelines: · the new location must provide minimum clearances around the stacker. These clearances are shown in the diagram...
9 technical data dimensions: width: 34” (864mm) 57.5” (1461mm) w/paper supports extended. Depth: 41” (1041mm) height: 28.5” (724mm) weight: 108 lbs. (49kg) paper size: 36 x 48” (914mm x 1219mm) max. Stacker capacity: 200 sheets of plain paper with minimal scatter 500 plain paper sheets max. Electric...
