Xerox C8 - DocuPrint Color Inkjet Printer Manual - page 23
D o c u C o lo r 8 0 0 0 / 7 0 0 0 S y s t e m A d m i n is t r a t i o n G u id e
1 -19
1 . D e c u r l e r A d j u s t m e n t
6. In the Decurler E Table Settings Type E window:
a. Enter the following values in the fields by pressing the
arrow buttons:
–
Since your job shows downward curl, you do not want
to use the Upward Decurler. As a result, in the Upper
fields you must enter values in descending order, or in
equal values less than 12% (the next value you will
enter). For this exercise we will use 0%, 0% and 0%.
–
In the Lower 2 mm (Light curl) field enter 12%. This
means that all pages with a 0% through 12% toner
area coverage, which includes the Dunn Report
maximum of 10.8%, are sent to the 2 mm downward
Decurler path.
–
In the Lower 6 mm (Medium curl) field, enter 30%.
This means that all pages with 13% to 30% toner area
coverage, which includes the Tulips 28.8%, will be sent
to the 6 mm downward Decurler path.
–
In the Lower 10 mm (Heavy curl) field, enter 50%.
Since none of your job pages have 31% through 50%
toner area coverage, this Decurler will not be used.
NOTE: Entering 50% in the Lower 10 mm (Heavy curl) field
simply illustrates that entering any value at or above 30%
(maximum of 100%) results in the same outcome. Since none
of your job pages have an image density ratio above 30% the
Lower 10 mm Decurler will not be used.
NOTE: Remember, all fields have to be considered (Lower and
Upper) when entering Decurler E Table Settings values.
The following screen shows how the values would be entered: