Xerox C8 - DocuPrint Color Inkjet Printer System Administration Manual - page 78
DocuColor 8000/7000 System Administration Guide
1-54
1. Tools Mode
20. Retrieve your output and assess the condition of each stack
for paper curl.
a. If the curl is eliminated in both stacks of the output,
continue printing the job.
b. If the curl in both stacks is in the opposite direction from
the original paper curl, additional adjustments are required;
proceed to Step 21.
c. If the curl is eliminated in one stack but not the other,
additional adjustments are required; proceed to Step 29.
21. Perform Steps 2-8 (in Step 4 select the same Paper Type E1
through E6 as used previously) and then proceed with Step
22.
22. Set the values in the
10 mm
and
6 mm
windows to
100%
.
23. Set the remaining window values to
0%
.
KEY POINT:
The above illustration is an example only. Your
actual E Table Settings for your print job may use different Upper/
Lower values than is shown above.
In this example, the
Upper 10 mm and
Upper 6 mm values
are changed to 100%.
The remaining values
are set at 0%.