Xerox D110 User Manual - page 259
Function
Component
No.
• This tray is standard on this finisher and is used to
load paper that will be used as separators and covers.
• Paper loaded here is not printed on; use this tray for
pre-printed stock and for insertion into the printed
output. (This tray is also known as the Interposer).
• Tray 8 holds a maximum of 200 sheets when using
20 lb./75 gsm paper.
• Paper can be loaded in the LEF or SEF direction.
Post-process inserter (Tray
8/Tray T1)
2
Collects the scraps from the puncher. Open to remove
the scraps.
Punch scrap container
3
Contains staples; remove this cartridge to replace staples
and clear staple jams.
Staple cartridge
4
Container for staple waste; remove this container when
full.
Staple waste container
5
The Top Tray is used for stacked output, and can receive
up to 500 sheets of 20 lb./80 gsm paper. Copies are
delivered here when specific output features are selected,
such as Automatic sorting, Collated, Uncollated, or
Normal.
Top tray
6
The Stacker Tray is used for offset and/or stapled output,
and can hold up to 2000 sheets of 20 lb./80 gsm paper.
This tray also receives copies when you punch and Z-fold
copies.
Note
Both the Top and Stacker Trays can be used for hole
punched output (optional).
Stacker (middle) tray
7
Open to clear paper jams, replace staples, clear jammed
staples, or remove the scraps from the puncher.
Right cover
8
The optional Folder tray receives copies when you select
C-folding or Z-folding of 8.5 x 11 in./A4 output and 11 x
17 in./A3 media.
C/Z-Fold output tray
(optional)
9
Open this cover to access the machine and to clear paper
jams.
Left cover.
10
Folding feature
If your machine is equipped with the Booklet Maker Finisher and/or the C/Z Folder, you
can make prints using the folding option. The option folds your prints in half (single or
bi-folding) or in thirds (C-fold or Z-fold types). The folding option is selected from the
print driver.
18-3
Xerox
®
D110/D125/D136 Printer
User Guide
Standard Finisher Plus