Xerox Phaser 3210 User Manual - page 81
P
ROBLEM
S
OLVING
7.3
Solving General Printing Problems
Problem
The printer does not
print. (continued)
Printer selects media
from the wrong
paper source.
Paper does not feed
into the printer.
Print job is extremely
slow.
Possible Cause
The printer may be
configured incorrectly.
The printer driver may
be incorrectly installed.
The printer is
malfunctioning.
The paper source
selection in the printer
properties may be
incorrect.
Paper has not been
loaded correctly.
There is too much paper
in the input tray.
The paper is too thick.
The job may be very
complex.
The maximum print
speed of the Xerox
Phaser 3210 printer is 12
pages per minute.
If using Windows 95, the
Spooling Setting may be
set incorrectly.
Solution
Check the printer properties to make
sure that all print settings are correct.
Uninstall the printer driver, then
reinstall the printer driver. Try printing
a demo page.
Check the lights on the control panel to
determine if the printer is indicating a
system error.
For many software applications the
paper source selection is found under
the Paper tab within the printer
properties. Select the correct paper
source.
Remove paper from the input tray and
reload it correctly.
Remove excess paper from the input
tray.
Use only paper that meets the
specifications required by the printer.
Reduce the complexity of the page or
try adjusting the print quality settings.
Access the Start menu, and then
choose Settings and Printers. Right-
click the Xerox Phaser 3210 PCL 6
printer icon, choose Properties, click
the Details tab, and then choose the
Spool Settings button. Select the
desired spool setting from the available
choices.