XK DHC-2 A600 Quick Start Manual - page 10
Landing
3D/6G Transform
Gyro calibration
-9-
Note:
In the process of gliding if the air route deviation can make the rudder correction. When the wind is too
large to control the plane in the downwind distance. To avoid unnecessary loss caused by the wind is too
large. Must be landing when the power of plane is came down. Don’t put the battery run out. If landing
not good must be need flight again and keep a little power. At First, open the Transmitter. put battery
into the plane, The plane on the ground or table.
Pls land immediately when the you feel the plane lack of
power. First of all, the plane flew to windward area adjust
the head and upwind landing. Pull down throttle and
reduce the flight speed. The plane will slowly slider down.
Until the plane touches the grounp. Then the throttle to
the lowest position. In the process of slide should be
adjusted according to the plane flight attitude .Keep the
plane glide smoothly.
1.Turn on is for 6G Mode. By pressing the aileron
joystick one second and change to 3D(Locking type)
2.3D mode flight.when plane in any position ,By
pressing Aileron joystick change to 6G mode.Plane
will be get back to the stable position.
3.6G Mode suitable for the begineer,3D mode can
do stunt.
gyro will be change accompany with the temperature and
accumulation error, Caused deviation in flight. Advise you
adjust again and Reset gyroscope.
1.At First, open the Transmitter. put battery into the plane,
The plane on the ground or table.
2.At the same time,put the left joystick and right joystick
to the left corner and right corner.
3.At this moment ,the signal red light of the plane will be
flashing and then blue flashing twice,when the signal
light of red and blue light long time.gyro Complete
zero calibration.