XK DHC-2 A600 Quick Start Manual - page 7
Perparation before flight
Landing gear installation
-6-
Front Landing gear put into head at the bottom of
the interface as shown A.And then back landing
gear Installed in the tail bottom interface as shown.
B.At last Install the front landing of Two pieces of
component into Front landing gear Support bar.
A
B
C C
A
B
C
Open the battery cover, The
battery connector in connection
with battery cover connector as
picture B Shown.
After connecting the battery, the
battery install into the battery
groove, And then close the
battery cover as picture “C”
Shown. When gyro
Self-inspection finish.
It can be flight.
Binding code of Transmitter and receiver
You buy the model before leaving the factory has been to code completion, if need to re-code,
please according to the following steps:
1. At first Open the Transmitter power switch
2. Put battery into simulated plane, the red light on the receiver will be lights, Press the button
of the receiver code about 1 second, the red light of receiver will be go out. When the red light
of receiver and blue light of signal light always on, to complete the code.
3. When binding pls avoid to open same type same frequency Transmitter surround. In order to
effect binding. This product is compatible with FUTABA S-FHSS. Can compatible with
FUTABA S-FHSS Controller on the market.
At first turn on the controller,
Make sure throttle joystick is
on the bottom position.