Xpr B100PROX-MF-SA User Manual - page 3
NOTE:
Swipe UPWARDS
to exit the MENU
Example:
Task: Set the Reader to work in “Finger and Card” mode
Scroll Master Finger 10 mes, tap, scroll twice, tap, scroll 4 mes, tap, swipe UP to exit.
OK Beep
Entry MODE
Back to MAIN MENU
Scroll down to select:
Finger
Finger OR PIN
Finger AND PIN
Finger OR Card
Finger AND Card
Finger ON Card
BL
BL
BL
BL
BL
BL
By swiping finger select entry
mode
11.8.1
Entry Mode, Remote Relay Touch Function
Double Swipe Unlocks Door,
Tap sensor
1 ON
2 OFF
Double Swipe
Unlocks Door
Double Swipe
Unlocks Door
Scroll down to select:
OK Beep
Back to MAIN MENU
Tap sensor
OK Beep
1 ON
2 OFF
Back to MAIN MENU
Remote Relay
Touch Function
Touch Button ON/OFF
Scroll down to select:
Tap sensor
BL
BL
Note:
Refer to Chapter 10 for this feature
BL
BL
product ver. 1.0.2.0.0
18
11.0 B100PROX-MF-SA P
M
ROGRAMMING
ENU
11.8 Settings
B100
-MF-SA is a simple one-door standalone biometric
) system. The reader can
PROX
and Proximity(Mifare
store up to 97 finger templates and 97
, it has one relay output and one exit button input. If
proximity cards
secure installation is needed, the reader can be connected to remote relay unit at secured area, which also
plays the role of
push button
request-to-exit
. Complete setup and programming can be done by scrolling and
tapping on the sensor.
The sensor incorporates dedicated sensing hardware to facilitate the detection of “spoofing” attacks based
on fake fingers. This data is embedded into the image data stream, and is processed on the processor. The
system is capable of detecting and defeating well-known fake finger mechanisms, such as molded “gummy”
fingers.
The coating on the surface of the TouchChip sensor provides protection from scratching and abrasion due
to normal contact with fingertips and any incidental contact with fingernails.
The reader is capable of working in so called “Finger on Card” mode, where the authentication is done by
verifying that the biometric data stored on the card matches the finger being placed on the reader.
Do not install the device and cabling close to a source of strong electro-magnetic fields like radio-transmitting antenna.
Do not place the device near or above heating equipments.
If cleaning, do not spray or splash water or other cleaning liquids but wipe it out with smooth cloth or towel.
Do not let children touch the device without supervision.
Note that if the sensor is cleaned by detergent, benzene or thinner, the surface will be damaged and the fingerprint can't
be entered.
If the biometric reader is installed and used outdoor, the reader MUST be fitted with the MCD-MINI polycarbonate cover
available in our accessories in order to protect the sensor from direct rainfall. The operating temperature of the product is
between -15ºC - + 60ºC. If the reader is installed in an environment where the temperature can drop below -10ºC or/and if
the sensor could only be exposed to direct sunlight, it is strongly recommended to install the reader inside a third party
sealed wall mount box (fitted with additional heater if very low temperature) to keep a constant sensor level performance.
XPR™ cannot guarantee the functionality of the product if measures and advice before are not followed.
It is also strongly recommended to use double technology biometric readers when use outdoor to offer first higher
security but also the possibility to use different readers depending on users.
100 mm
94 mm
30 mm
Cable
Ø6.0
30
m
m
MCD-MINI
3
1. DESCRIPTION
2.0 MOUNTING