Xsories Weye Feye User Manual - page 12
WIFI TUNING
7
WiFi CHANNEL TUNING GUIDE FOR
DEMO
SCOPE
This document is used to guide the one who is
going to setup booth on the show. There are many
WiFi signals in the show and in order to have best
performance for live demo, we need to choose best
WiFi signal channel.
PROBLEMS
WiFi signal interference exists and it’s always there.
Signal quality is degraded when there are many WiFi
hotspots in the same area. When there’s interference
the WiFi bandwidth will be reduced greatly. Then if
you are using Weye-Feye, you will find that the delay
on mobile phone is serious.
SOLUTION
There are 12 channels for WiFi signal. To tune the
WiFi signal, choose the best signal channel for our
product for it to be much less affected by other
hotspots.
STEPS
Go to “Play Store” on Android phone (It used
to be “Android Market”).
Search for “WiFi Analyzer” and install it.
Open this App and
you will find a chart like
below. It’s the signal
strength of WiFi signal
around you.
You can find that there are some numbers
under the chart from 0-14. That’s the WiFi
channel.
The higher the parabola is, the stronger the
signal is.
Weye-Feye’s WiFi signal ID named after weye-
feye so you can find it with purple
parabola in the chart. Here in the chart it is in
Channel 6 (center is on channel 6).
The way we do tuning is to find out the clean
(weakest signal channel) number
with this analyzer. Here Channel 9 is the best choice.
Power on Weye-Feye.
Connect your cellphone to Weye-Feye’s
hotspot.
Open your browser and key in:
http://192.168.1.2:8080/wpa_ctrl?ch=
N
Here
N can be 0 to 11. In this case, as we will choose
Channel 9 so we will key in:
http://192.168.1.2:8080/wpa_ctrl?ch=9
Then type enter and wait. WiFi signal will
disappear for a few seconds and
reconnect again.
Please open “WiFi Analyzer” again and check
the WiFi channel, it will be switched
to the channel you typed in.
1
2
3
4
5
6
7
8
9
10
11
12
12