Xterra 16204770480 Owner's Manual - page 9

customerservice@dyaco.ca

Dyaco Canada Inc 2017

9 

STEP 3

1.  Insert the handlebar post (17) to the main frame (16). Secure using a quick release knob (7).

2.  Remove 4 sets of spring washer (19) and allen screw (20) from handlebar post (17). 

3.  Attach the handlebar (18) to the handlebar post (17). Secure using 2 sets of spring washer (19) 

and allen screw (20) at the 2 lower screw holes. 

4.  Attach computer bracket (64) to handlebar (18) and secure using 2 sets of spring washer (19) and 

allen screw (20) at the 2 upper screw holes.

5.  Attach computer (65) onto the computer bracket (64) and secure using 2 screws (68) which are 

pre-assembled on the backside of computer (65). Attach sensor wire (69) to computer (65).

Note: The handlebar post can be adjusted vertically. 

STEP 4 

1. 

Attach the left pedal (1L) to the left crank (33). 

2. 

Attach the right pedal (1R) to the right crank (36). 

Note: The right pedal should be threaded on clockwise and the left pedal on counter-clockwise. 

YOUR UNIT IS NOW FULLY ASSEMBLED