Xterra 16416880-1 Owner's Manual - page 9
Customer Service 1-888-707-1880 Maurice Pincoffs Canada Inc
©2011
8
Console Installation:
The console carton consists of a computer console, speed sensor transmitter and one heart rate
chest belt. The transmitter counts the number of times the magnet, which is mounted on the crank
assembly, passes the sensor. The speed sensor transmitter will then send a coded signal to the
console which contains the measured value (Speed and Cadence ).
Both the computer console and the speed sensor transmitter use AAA type batteries. Please
install the AAA batteries in the computer console and speed sensor transmitter before using.
Battery Installation:
1. Remove the battery cover from the back of the computer.
2. Insert 2 AAA batteries into the battery compartment and reinstall the battery cover.
3. When Battery working voltage is too low, The “Low battery” indicator will show up on the
console display indicating it is time to change the batteries.
Speed Sensor Transmitter Battery Installation
1. Remove the battery cover from the transmitter.
2. Install 2 AAA batteries in the battery compartment and reinstall the battery cover.
3. When new batteries are installed in the transmitter or console you must perform the
synchronizing procedure below for the console to work properly
Synchronizing the transmitter to the console:
After installing the batteries, and before attaching the console and transmitter to the bike, you
must synchronize the two so they can ‘talk’ to each other.
Press and hold the two keys on the front of the console for about 3 seconds until the display
shows ID - -
Now press and hold the blue button on the transmitter for 3 seconds and release. The console
display should show ID 0. NOTE: You must press the blue button within 10 seconds after the
console is showing ID - - otherwise the console will show: ID ER. If the console shows this error
then restart the procedure again.
It may be necessary to remove and re-install the batteries in both the console and transmitter if
you continue to receive an error.
Console Installation:
1. Install the mounting clamp (2) to the back of the console (1) with the clamp mounting screw (3).
2. Install and slightly tighten the thumb screw (4) then adjust the console angle for optimal visibility.
Once the console is adjusted, continue to tighten the screw until it is securely attached to the
handle bar.
Installing the speed transmitter:
Plug the speed sensor wire into the transmitter (6) and then attach the transmitter (with Velcro
pre-attached to the back) to the Velcro half that is pre-installed to the bike frame. The Velcro is
mounted to the back side of the chain cover, below the left crank.