Yaesu G-550 Instruction Manual - page 4
P
AGE
2
G-550 I
NSTALLATION
M
ANUAL
UNPACKING & INSPECTION
When unpacking the rotator confirm the presence of the following items;
Rotator Unit ......................................................................................... 1
Controller Unit .................................................................................... 1
7-pin Metal Connector ........................................................................ 1
Water Resist Cap ................................................................................. 1
Instruction Manual .............................................................................. 1
Plastic Bag containing;
8mm Spring washer ................................................................. 8
8mm Nut .................................................................................. 8
8mm Flat washer ..................................................................... 8
8mm dia Stud bolt ................................................................... 4
Pipe clamp ............................................................................... 6
U-Bolt ....................................................................................... 2
6mm Flat washer ..................................................................... 4
6mm Spring washer ................................................................. 4
6mm Nut .................................................................................. 4
Spare Fuse (117V;1A, 220V; 0.5A) ........................................ 1
If any of these items are missing or appear to be damaged, save the carton and pack-
ing material and notify the shipping company (or dealer, if purchased directly at his
shop).
Before proceeding with installation, confirm that the AC voltage label on the rear of
the Controller matches your local line voltage: either “117V” for 110 to 120 VAC,
“220” for 220 to 240 VAC. If the labeled voltage range does not match, return the
controller to the dealer from whom you purchased it (different power transformers are
installed for the different voltage ranges).
Note that cable is not included with the rotator, as the length must be determined case-
by-case. Contact your Yaesu dealer to obtain the length of cable your installation
requires. For runs of over 100 feet, use #18 AWG instead of #20 AWG.