Yale ENA-PIR Instruction Manual

Wirefree Yale ENA-PIR

Passive infrared  motion 

detector

Features:

1.   Test/Learn Button

To enter Test mode: Press once in Standby mode.  

The LED will light up for two seconds whenever a  

movement is detected.

2.   Red LED Indicator

3.   Knockouts for Wall / Corner Mounting

4.   Supervision Enable / Disable Jumper

5.   Movement High/Low Sensitivity jumper

6.   Tamper Switch with spring

7.   3x 1.5V AA Alkaline Battery

8.   Tilt Switch 

(protect against unauthorized EIR  

removal, sabotage, or loose installation)

9.   Top & Bottom Cover securing screw hole

Pack content:

1 x PIR

4 x Screws

4 x Wall Plugs

Supervision Enable/Disable Jumper

After installation, the PIR will automatically transmit 

Supervisory signals periodically to the Control Panel 

at random intervals of less than 20 minutes. If the 

Control Panel has not received the signal from the 

PIR for the preset period of time, the Control Panel 

will indicate on its display that the particular PIR is 

experiencing an out-of-signal problem.

Jumper On= Supervision Disabled

Jumper Off= Supervision Enabled (Default)

Movement High/Low Sensitivity Jumper

Jumper On= Increase PIR sensitivity to movement

Jumper Off= Decrease sensitivity (Factory Default)

SmartHome Alarm series

2

1

3

7

8

4

5

6

9