Yale ENA-PIR Instruction Manual - page 3
Operation
Sleep Timer
The PIR features an automatic “sleep time” of
approximately one minute for power conservation.
After transmitting a detected movement, the PIR
will not retransmit for one minute. Any further
movement detected within this one-minute sleep
period will extend the sleep time by another
minute. Disable the sleep timer temporarily by
entering the test mode. See Test Mode section.
LED indicator
Off
Normal operation
LED flash
(2 sec)
- Detects motion during Low
battery, Tamper activated or Test
mode.
- Spring/Tilt tamper switch is
activated.
Tilt Switches/Tamper spring
With the PIR placed in an upright position:
•
Turning left and right
Tamper Activate when
Turning clockwise more than 45 degree
Turning anti-clockwise more than 135 degree.
•
Tilting Up and down
Tamper Activate when
Turning down (lens pointing to the floor) more
than 110 degree
Turning up (lens pointing to the ceiling) more
than 80 degree.
By turning the PIR the other way (back to the
original upright position) will cause it to send a
“tamper restore” signal back to the control panel.
Opening the unit will also trigger tamper alarm via
the tamper spring
Test Mode
Press Test button/LED once to enter test mode.
Under test mode, the sleep timer is disabled
and the LED lights up whenever movement is
detected. The device will auto exit test mode after
3 minutes.
Changing Batteries
The 3 x 1.5V AA size alkaline batteries have a
battery life of approximately three years (based
on 20 activations per day). When the low battery
condition is shown, the device should have
enough power to operate for one month.
Step 1: Login to the engineer menu on the
control panel.
Step 2: Dismount the PIR and remove the
batteries. Press Test button for ten times.
Step 3: Insert 3 x new 1.5V AA alkaline batteries.
Step 4: Replace the cover and mount the sensor.
Step 5: Exit the engineer menu and return to
standby on the control panel.
Specification
Environmental conditions:
-10c to 40c , relative humidity 85% non-
condensing. Indoor use only
Radio
868.35MHz FM
Battery:
3x 1.5V AA Alkaline
Dimension:
92.4mm x 66.5mm x 60mm
Standard :
EN300-220-1
EN301489-1,3
EN60950
PD6662:2010 Grade 2 Class 2