Yamaha BANSHEE YFZ350S Owner's Manual - page 141
3. After adjusting, be sure to tighten the lock-
nuts and the wheel hub bolts.
EBU00805
Lubricating the drive chain
The drive chain must be cleaned and lubricat-
ed at the intervals specified in the periodic
maintenance and lubrication chart, otherwise
it will quickly wear out, especially when riding
in dusty or wet areas. Service the drive chain
as follows.
c
C
The drive chain must be lubricated after
washing the ATV or riding in the rain.
1. Clean the drive chain with kerosene and a
small soft brush.
c
C
To prevent damaging the O-rings, do not
clean the drive chain with steam cleaners,
high-pressure washers or inappropriate
solvents.
Upper wheel hub bolt:
120 Nm (12.0 m
0kgf, 85 ft0lbf)
Lower wheel hub bolt:
60 Nm (6.0 m
0kgf, 43 ft0lbf)
q
w
e
1. Locknut
2. Adjuster
3. Alignment marks
8-38
5FK-9-16-03 3/13/03 8:39 AM Page 39