Yamaha ClickStation Owner's Manual - Preparing For Use
14
Preparing for Use
■ Using Battery Power
1. Prepare one alkaline battery (6LR61: 9V, S-
006P).
* A manganese battery can be used but battery life
may be extremely short depending upon the battery
type.
2. Make sure that the power switch is set to its
OFF position then remove the battery cover
from the rear panel.
3. Check the alignment and polarity markings
(+/–) on the battery, attach the battery to the
battery terminal then replace the battery
cover.
■ Using a Power Adaptor
1. Make sure that the power switch is set to its
OFF position, then connect the power
adaptor’s DC plug into the device’s DC IN 9V
jack.
2. Connect the power adaptor’s AC plug to an
AC wall outlet.
* When battery power gets low, the volume output
will be reduced or the display will grow dim. If this
is the case, replace the battery with a new one as
soon as possible.
* If the power adaptor is connected when a battery is
installed in the device, power is automatically sup-
plied from the power adaptor.
* Make sure only the specified power adaptor is used.
The use of any power adaptor other than the one
specified may result damage, fire, etc. Doing so may
void the warranty even if the device is still within
the warranty period so please use caution.
Power adaptor
Power adaptor jack
Cautions Regarding Memory Backup
• This device has no data backup capabilities to preserve data when the battery is removed or when the AC adaptor is
disconnected.
• If the device is left without power supplied from a battery or AC adaptor, song and chain program data created by the
user will be lost.
• To replace the battery without loosing data connect the AC power adaptor to the device while changing the battery or,
change the battery before battery power is completely exhausted and complete the battery changing procedure within
3 minutes.
• The device’s vibrator grows weak as battery power depletes.
• When the display dims, the battery should be replaced as soon as possible.