Yamaha ClickStation Owner's Manual - Using The Metronome

15

Using the Metronome

Start the Metronome’s Audio Click

q Press the CLICK button.

w Press the START/STOP button to start the

metronome.

e Use the Quarter Note and VOL volume con-

trol sliders to increase the volume level.

* The VOL slider is used to control the device’s over-

all volume level. When the VOL slider is set to [0]

(all the way down), no sound is produced.

[Using the VIBRATION feature]

r Press and hold the VIBRATION pad and the

vibrator will pulse in tempo with the metro-

nome. When the metronome is stopped only

the vibrator and flashing beat indicator will

operate.

Use the VIB. slider to adjust the amount of

vibration.

Adjust Beat Volumes

q Use the volume sliders q for each beat to

adjust individual beat volumes. (Shown in

the illustration above)

Change the Tempo

z Rotate the TEMPO dial to adjust the tempo

(35 - 300).

[Using the ten-key pad to set the tempo]

z Press the TYPE TEMPO button. (Lamp lights)

x Use the ten-key pad to set the tempo value.

c Press the START/STOP button and the metro-

nome will start at the tempo you just entered.

v Press the TYPE TEMPO button to cancel the

setting. (The lamp goes off.)

* When the TYPE TEMPO lamp lights, the ten-key

pad is in the tempo setting mode. Turn the TYPE

TEMPO lamp off when you want to use the CLICK,

SEARCH, or other function buttons.

* To change the tempo when the metronome is in use:

• If the START/STOP button is pressed in step 3, the

tempo will change from that instant (from beat 1).

• If the TYPE TEMPO button is pressed in step 3,

the tempo will change from the next beat.

Change the Beat

Press the BEAT button and the BEAT value

shown on the upper left corner of the display will

flash. While the BEAT value is flashing, press

the BEAT button to set the beat value between

0 and 9. After 2 seconds, if the button is not

pressed, the beat setting is entered and the dis-

play will return to its original display.

* When the beat is set, the ACC. tone will sound on

the first beat of every measure. If the beat is set to

[0], the ACC. tone will not sound.

[Use Beat 2 to create a complex beat or

subdivisions]

Press and hold the BEAT button for more than 2

seconds and the COUNT value located next to the

BEAT value will flash. While the COUNT value is

flashing, press the BEAT button to set Beat 2 to a

value between – and 9. After 2 seconds, if the but-

ton is not pressed, the beat setting is entered and

the display will return to its original display.

* The Beat 2 setting can be used to create complex

beats over 2 measures (subdivisions).