Yamaha DJX Owner's Manual - Tion to Standby.

101

MIDI FUNCTIONS

3

At the “InitSnd?” prompt above, set the opera-

tion to standby.

Press the + button.

4

Start recording on the sequencer, then send the

Initial Setup data.

Start recording on the sequencer in the normal way, then — with as

little delay as possible — press the + button to actually start transmit-

ting the data.

An “End” message briefly appears in the display when the operation

is complete, followed by the “InitSnd?” prompt.

5

Stop recording on the sequencer.

Stop recording on the sequencer in the normal way.  Make sure that

any subsequently recorded performance data is recorded at least one

measure following the Initial Setup data.

6

Exit from the Initial Setup Send operation.

To exit from Initial Setup Send, press one of the other mode buttons:

SONG, STYLE, or VOICE.

STYLE

YES

FUNCTION

Sure?