Yamaha PJP-25UR User Manual - page 15
13
OP
ERA
TIONS
0
Operation mode setting
Select the operation mode of this unit. To enable both the
microphones and speaker (as in the case of a conference),
click "Mic&Speaker". To enable only the speaker (as in
the case of listening to music), click "Speaker".
If the operation mode is set to "Mic&Speaker", this unit outputs
left-channel audio only regardless of audio signal type.
■Items in the DETAIL screen
A
Environment
Switch between "Normal" and "Conference Room",
depending on the environment.
• Normal (default): when using in the normal
environment
• Conference Room: when using in the quiet
environment like a conference room
B
Mic Voice Band
Configure the microphone's voice band setting. Select a
microphone's voice band mode ("Wide", "Normal", or
"Narrow") suitable for your Web conference application.
C
Mic Level
Adjust the microphone sensitivity using the slider bar.
D
Input Level
Adjust the audio input level (amplification) in the range of
-12.0 to +12.0 dB using the slider bar. This setting is
applied to inputs from another device through the audio
cable.
E
Output Level
Adjust the audio output level (amplification) in the range
of -12.0 to +12.0 dB using the slider bar. This setting is
applied to outputs to another device through the audio
cable.
F
Mic & Speaker Control via USB
Enable or disable the interlocking volume control between
the PJP-25UR and PC. Set this item to "ON" or "OFF"
depending on the specification of your communication
application.
You need to restart the PJP-25UR if this setting is changed.
Follow the instructions on the screen to restart it.
G
Audio Test
Check the audio in the current setting. For details, refer to
"Testing the audio" (page 16).
H
Save/Restore Settings
Save the settings of this unit. For details, refer to "Saving
the settings of this unit" (page 15).
I
Reset
Reset the settings of this unit. For details, refer to
"Resetting the settings of this unit" (page 16).
To complete the reset operation, you need to restart this unit in
some cases. If the message to restart this unit appears, follow the
message to restart it.
Note
Note
Note