Yamaha PLG100-VL Owner's Manual - page 18

18

5. Scream

Scr CC No. (Scream Control Change Number) ....... Settings: off … 95, AT, VEL, PB

“Scream” drives the entire system into chaotic oscillation, creating effects that can

only be achieved with physical modeling technology. The “Scr CC No.” parameter

specifies the controller to be used for scream control. When set to “off” no scream

variation can be produced via a controller, but a continuous scream value is deter-

mined by the “ScrCtrlDpt” parameter, below (negative values increase the scream

level).

TngCtrlDpt (Tonguing Control Depth) ................................... Settings: -64 … +63

Sets the amount of variation produced by the controller assigned to tonguing. The

higher the value the greater the variation. Positive values cause an decrease in tongu-

ing in response to higher controller values (e.g. increased breath pressure or higher

modulation wheel position), while minus values cause an increase in tonguing in re-

sponse to higher controller values.

Editing VL Voice Part Parameters

4. Tonguing

Tng CC No. (Tonguing Control Change Number) .. Settings: off … 95, AT, VEL, PB

“Tonguing” simulates the  half-tonguing technique used by saxophone players by chang-

ing the “slit” of the reed. The slit is the space between the tip of the reed and the

mouthpiece. The “Tng CC No.” parameter specifies the controller to be used for tonguing

control. When set to “off”  no tonguing is applied.

• Please note that accurate keyboard pitch is produced only when maximum tonguing is applied or the tongu-

ing controller is turned off.