Yamaha SB168-ES Quick Start Manual - The Basics;
M7CL Quick Start Guide Part 1
9
Changing the channel parameters. HA popup; +48V.
Once you have assigned channels either to an eight or single channel view you can begin to modify their param-
eters. There is no need to enter menu systems for most basic parameters found on analogue consoles.
The Basics;
From the eight channel overview screen parameters
can be adjusted using the eight encoders below the
screen. Just touch the row of screen knobs (HA or Mix
send) and turn the corresponding encoder.
From the single channel view you can see the effect of
changing any of the encoders to the left of the screen.
To get more detail of a particular parameter just touch the screen again. From either main screen press the feature
you require (for example HA control) and a pop-up will appear.
Press
Press
Press
Press
To close pop-ups press the [X].
Tip;
Tip; Or press anywhere
outside the pop-up in the
grey area.
Touch the screen in the same way to access pop-ups for; Insert and Direct send, EQ and Attenuator, Dynamics 1 and
2, Mix Send, Pan/LCR routing, DCA and Mute group, Name/Icon/Patch, Recall Safe, etc.
From the HA/PATCH pop-up you can still
adjust HA gain but now you can also add
+48V phantom and change polarity Ø.
You can go to the NAME/PATCH pop-up
or using the tabs below see overviews
of eight or all channel HA details.
Tip;
Tip; There is a +48V master switch
on the SETUP page. If condenser mics
don’t work check the master switch!