Yamaha T3n Owner's Manual - page 13
T5n/T4n/T3n Owner’s Manual
13
Specifications
These specifications apply to rated power supplies of 120 V, 230 V and 240 V.
Half Power = 3 dB below rated power
1/8 Power = 9 dB below rated power
0 dBu = 0.775 Vrms
Specifications and descriptions in this owner’s manual are for information purposes only.
Yamaha Corp. reserves the right to change or modify products of specifications at any time without prior notice. Since specifications, equipment or options
may not be the same in every locale, please check with your Yamaha dealer.
European models
Purchaser/User Information specified in EN55103-1 and EN55103-2.
Inrush Current: T5n 24 A, T4n 8 A, T3n 6 A
Conforms to Environments: E1, E2, E3, E4
All Models
THD + N
20 Hz-20 kHz, Half power, RL = 4
Ω, 8 Ω
MAX
0.1 %
Intermodulation Distortion
60 Hz:7 kHz, 4:1, Half power
MAX
0.1 %
Frequency Response
RL = 8
Ω, Po = 1 W
20 Hz-20 kHz
MAX
0 dB
TYP
0 dB
MIN
-0.5 dB
Channel Separation
Half power, RL = 8
Ω, 1 kHz
Att. Max, input 600
Ω shunt
MIN
67 dB
Damping Factor
RL = 8
Ω, 1 kHz
MIN
800
Voltage Gain
Att. Max
TYP
32 dB/26 dB
Maximum Input Voltage
MIN
+24 dBu
Input Impedance
TYP
20 k
Ω (balanced) 10 kΩ (unbalanced)
Controls
Front Panel
POWER switch (ON/OFF)
Attenuator (31position) x 2
Rear Panel
MODE switch (STEREO/BRIDGE/PARALLEL) x 1
GAIN switch (32 dB/26 dB) x 1
AMP ID switch (6P DIP) x 1
Connectors
Input
XLR-3-31 type x 2
Euroblock connector (balanced) x 2
Output
Speakon x 2, 5-way binding post x 2 pairs
DATA PORT
RJ45 x 2
Indicators
POWER/STANDBY
x 1 (Green/Orange)
REMOTE
x 1 (Green)
PROTECTION
x 1 (Red)
TEMP
x 1 (Red) heatsink temp
≥ 85 °C
SIGNAL
x 2 (Green)
MUTE
x 2 (Red)
CLIP
x 2 (Red)
Load Protection
POWER switch ON/OFF mute
DC-fault: Amplifier shuts down automatically.
Clip limiting: THD
≥ 0.5 %
Amplifier Protection
Thermal: Mute the output (heatsink temp
≥ 90 °C)
(return automatically.)
VI limiter (RL
≤ 1 Ω): Limit the output.
Power Supply Protection
Thermal: Amplifier shuts down automatically.
(heatsink temp
≥ 100 °C)
Cooling
Continuously variable-speed fan x 2
Power Requirements
US: 120 V/60 Hz
EU: 230 V/50 Hz
A: 240 V/50 Hz
Power Cord Length
1.5 m
Dimensions (W x H x D)
480 x 88 x 447 mm
Weight
14.0 kg
Included Accessories
Handle x 2 (with flat-head screw x 4),
Euroblock connector x 2, Owner’s Manual